InfinID Technologies, Inc. V-TAG RFID Tag and USB Gateway V2.
Table of Contents 1.0 System Overview ...................................................................................3 2.0 Getting Started .......................................................................................4 3.0 Viewing Sensor Readings ......................................................................5 Appendix A FCC Compliance Statement ....................................................9 V2.
1.0 System Overview The V-TAG is a RFID tag with a set of sensors for temperature, acceleration and battery level. In contrast to other systems where each tag is polled by a central gateway, the VTAG tag relays messages from other V-TAG tags which aids with tag read range and communications reliability. See Figure 1. Figure 1 V-TAG System Overview V2.
2.0 Getting Started To start using your V-TAG RFID tags, insert batteries into each tag. The LED light on the tag should blink once every 20 seconds indicating normal operation. To start using your V-TAG USB Gateway, attach the gateway to a USB port on a PC running Windows 10 or Windows 11. Select “OK” when the operating system asks to use the Internet to locate drivers. Install the InfinID Technologies, Inc. AssetWorx! asset tracking software on your PC by running setup.exe and following the prompts. V2.
3.0 Viewing Sensor Readings To associate a V-TAG tag with an asset, simply enter the V-TAG ID printed on the tag label into the VTAG ID field for the asset as shown: V2.
To view sensor readings for the asset, choose the sensors tab for the asset: V2.
To view historical sensor readings for the asset, click on the “Plot” button for the asset: V2.
To set thresholds for the asset, click on the thresholds button for the asset: V2.
Appendix A FCC Compliance Statement FCC NOTICE This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference and 2. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
