4.2 PROGRAMMING THE NEW. CB440, CB475, CB511 AND CB514 The Address and Mode for each all box: are listed in the Store Installation and Operation Manual for the specific store install. Refer to the data tables in Appendix A of that manual for the correct Address and Mode for each call box you are programming: Notes earlier medals of hiss call bones ave nor "Mode? programmable tei do not ave JP. Before programming a new-call box, identify what version of circularized is installed in the nil. per.
depending on the jumper position of JP4 on ibe call bax circuit board and is identified by the second digit of the Mode Programming. Default sett ir JP4 is jumper on both pins. + Call boxes programmed with"Narrow Pulse Width Mode Enabled”; will only work with a CB4S18 Receiver. Jumper must be installed on JP. + Call Boxes programmed with "Wide Pulse Width Mode Brabled®, will work with 2 CB4S1A Receiver or a CB451B Receiver.
Channel 1'is programmed as an External momentary input and transmits as a standard call box "Channel 14 SET. When alarm state is removed, a RESET is sent. Mode 6 CU3000 Compatible = 8 min timeout (4 programmable changeless Mode 1:is compatible with CLI3000 systems. This mode will: not send a supervisory.
1: Remove the JPA jumper. 2. Jumper both pins of JP3. 3.7 Press Litton 1 twice {for Mode 2). Button #1 LED will flash for each press: 4.7 Press RESET! 5. Press Litton 1 twice (for Wide Pulse Width), LED will flash for cache press. 6. Press RESET, Witch us Button 1 LED flashes two times (for Mode 2), pauses, and then flashes twice (for "Wide Pulse Width"): 7. Remove the jumper from JP3. Do not install a jumper on JP4. 4.