Installation Instructions

Technical Document

CB514 Install Instructions 1 P/N: 430223-01 Rev B

CB514 Installation And Programming Instruction

Individual callbox addresses should be determined prior to starting the installations. As an un-

programmed callbox defaults to an address of 001, this position in the control unit may be left

blank or have an advisory message.

Location Considerations

Director call boxes are generally best located in high volume

areas that demand a way to request additional services quickly,

such as front registers or service counters. Stores and installers

should be aware of Americans With Disabilities Act (ADA)

requirements for accessibility.

The call boxes utilize a very low powered transmitter, and operate

best with a clear line of sight to the nearest receiver. Tall shelving,

merchandise and metal signs can block or reduce the callbox

signal.

Install the CB514 Call Box

1. Verify call box and clear plastic label sleeve placement with the Store Manager. (The label

sleeve is optional and may not be used in all applications.)

2. Identify which side of the CB514 the label sleeve should be attached for the best visibility

and avoiding damage (the sleeve can be mounted on the left or right side of the call box).

3. Slide the label into the clear plastic sleeve (double-sided tape or Velcro will be installed on

the bottom of the label sleeve).

Programming the CB514 Call Box

To program the CB514, program the first button and the remaining three buttons are automatically

programmed with the next numerical values. When the call box "flashes" the newly programmed

address, the zero value will be indicated by a longer (slightly over a second) flash. For example: an

address of 001 would be shown as long flash (0), pause, long flash(0), pause, and a short flash (1).

NOTE: IF INSTALLED, JUMPER JP2 MUST BE REMOVED DURING PROGRAMMING.

WHEN POWERED UP, THE CALL BOX WILL DEFAULT TO 001.

The Address and Mode for each call box are listed in the Store Installation and Operation

Manual for the specific store install. Refer to the data tables in Appendix A of the Store

Installation and Operation Manual for the correct Mode and Address for each call box you are

programming.

1. Press and hold the RESET button for approximately 5 seconds.

2. LED 1 will flash to indicate the call box is in address programming mode.

3. Press button 1 to increment the hundreds digit. LED 1 will flash with each press.

4. Press the RESET button when finished with the hundreds digit.

PAGE 1
Technical Document CB514 Installation And Programming Instruction Individual callbox addresses should be determined prior to starting the installations. As an unprogrammed callbox defaults to an address of 001, this position in the control unit may be left blank or have an advisory message. Location Considerations Director call boxes are generally best located in high volume areas that demand a way to request additional services quickly, such as front registers or service counters.
PAGE 2
Technical Document 5. 6. 7. 8. 9. Press button 1 to increment the tens digit. LED 1 will flash with each press. Press the RESET button when finished with the tens digit. Press button 1 to increment the ones digit. LED 1 will flash with each press. Press the RESET button when finished with the ones digit. The address just programmed should flash back on the LED 1 with a pause between each digit. (Note: the LED will indicate a zero value by staying on for a longer period of time, approximately 1 second).