User's Manual

ManualsBrandsIndyme Solutions ManualsElectronicsWireless Help Button

Technical Document

430735-01

Rev. F

Indyme Solutions, Inc. 8295 Aero Place  San Diego, CA 92123 USA +1.858.268.0717  +1.800.829.6141 Page 1 of 5

CB961 Wireless Help Button

Programming and Installation Instructions

Overview

The CB961 is a member of the Global Solutions Family. Indyme GSF products

operate in the 800MHz – 900MHz frequency spectrum. The CB961 help button is

designed for use at various customer service locations. GSF help buttons

communicate with an Indyme GSF Access Point. GSF products are not compatible

with legacy Indyme infrastructure and devices.

Hardware

 (3) #6 x 3/4 Phillips screw

 (3) #6 plastic wall anchor

Programming Parameters

GSF products MUST be properly programmed to establish communication.

Programming parameters MUST match your configuration. The default settings are for

testing purposes only and should not be used. Failure to properly program your help

button and access point will prevent your devices from working.

GSF help buttons have three primary programming parameters; Netcode, Address and Operating Mode. These

MUST be programmed in the correct order to establish communication and ensure proper operation. Identify the

parameters for your configuration before you begin programming.

Using the programming instructions below set the following parameters in order.

 Netcode – unique identification code for the installation environment.

 Address – alarm number associated with a control unit alarm event.

 Operating Mode – defines how the help button will respond when activated.

Programming a help button requires a series of button presses. The specific buttons vary by help button type.

On the CB961, SET is the “Press for Assistance” button and RESET is a small oval below the SET button. The

assurance LED is red and is located BEHIND the SET button. This LED will flash during programming to indicate

your progress.

Netcode

*00000001

Address

*0001

Operating Mode

* Default parameters are for testing purposes only.

RESET

Summary of content (5 pages)

PAGE 1
Technical Document 430735-01 Rev. F CB961 Wireless Help Button Programming and Installation Instructions Overview The CB961 is a member of the Global Solutions Family. Indyme GSF products operate in the 800MHz – 900MHz frequency spectrum. The CB961 help button is designed for use at various customer service locations. GSF help buttons communicate with an Indyme GSF Access Point. GSF products are not compatible with legacy Indyme infrastructure and devices.
PAGE 2
GSF Help Button Programming GSF help buttons function in the 800MHz – 900MHz frequency spectrum. These wireless transceivers communicate with the Indyme CB951 Access Point. Each help button MUST be programmed with the correct parameters to match the CB951 Access Point(s). Help buttons use a hierarchy based menu structure. You must enter the Programming Menu first, to select the desired submenu. Each submenu may have one or more options available.
PAGE 3
Menu-3: Operating Mode Assigns the help button operating characteristics; timeout duration, RESET signal and number of active buttons. Although set at the help button, the Operating Mode can be reset and overridden by the control unit. Operating Modes will vary by help button type, below are the default modes for this help button. After entering the Programming Menu; Press the SET button three times for Menu-3, RESET once to save.
PAGE 4
Location Considerations Help buttons are typically located at cash registers, service counters or other areas in which customers may require assistance. Stores and installers should be aware of the Americans with Disabilities Act (ADA) requirements for accessibility. Technical Document Help buttons use a low powered transmitter, and operate best with a clear line of sight to the nearest receiver. Tall shelving, merchandise and metal signs can block or reduce the help button signal.
PAGE 5
Technical Document FCC Notice of Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.