User's Manual

Technical Document

430668-00

Rev. E

Indyme Solutions, Inc. 8295 Aero Place  San Diego, CA 92123 USA +1.858.268.0717  +1.800.829.6141Page 1 of 2

CB526 Pocket Director Call Box

Programming the CB526:

If at any point during the programming sequence 30 seconds expire without a button being pressed, the address

programming mode will be exited and the previously programmed address will continue to be used. The

assurance LED will flash 5 times to indicate that mode programming has been exited.

1. Press and hold button 2 for 5 seconds. The assurance LED will flash once.

2. Press and hold button 1 for 5 seconds. The assurance LED will flash twice.

3. Press and hold button 2 for 5 seconds. The assurance LED will flash three times.

4. Press button 1 once.

5. Press button 2 once, the assurance LED will flash once.

You are now in Address Programming Mode.

6. To program the hundreds value, press button one 1-9 times.

7. Press button two, one time to save the hundreds value.

8. To program the tens value, press button one 1-9 times.

9. Press button two, one time to save the tens value.

10. To program the ones value, press button one 1-9 times.

11. Press button two, one time to save the ones value.

The assurance LED will now flash back the address that was programmed.

NOTE: To program the number zero (“0”) do not press button 1, instead, press 2.

During the flash back sequence, the LED indicates a zero by staying on longer.

The CB526 is a mini director call box designed for pocket or

clip-on use. The 4-membrane switch assembly is

designed without a reset button and is intended to be carried

by store employees desiring to trigger messages from various

locations within the store.

The CB526 call box has a single assurance LED, it will flash for

¼-sec when a button is pressed.

PAGE 1
Technical Document 430668-00 Rev. E CB526 Pocket Director Call Box The CB526 is a mini director call box designed for pocket or clip-on use. The 4-membrane switch assembly is designed without a reset button and is intended to be carried by store employees desiring to trigger messages from various locations within the store. The CB526 call box has a single assurance LED, it will flash for ¼-sec when a button is pressed.
PAGE 2
Technical Document 430668-00 Rev. E FCC Notice of Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Class B statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.