User's Manual

Table Of Contents

Technical Document

CB520 Wireless Director Call Box

Programming and Install Instructions

Scope

This document covers all the necessary instructions for installing the CB520 Call

Box and how to program the call box, using the front panel and the Status LEDs

indicators. The CB520 is programmed to work with the Indyme MTS (Messaging

and Telephony Server). Additional information regarding this call box can be

found in TSN001- Wireless Call Boxes, Indyme part number: 435001-00.

Overview

The CB520 is a programmable 12 button Director Call Box, which can be

programmed to any address between 1 and 988. The Status LEDs are

illuminated during programming and various stages of call box operation. The

CB520 has five programmable modes. Each mode is identified in this document.

Programming

Use Buttons 1, 2 and 3 on the front of the call box to program each channel.

1. Put jumper on JP3.

JP2 and JP3

2. Press Button 1 for the hundreds value

(the TX LED will flash).

3. Press Button 2 for the tens value (the

ACTIVE LED will flash).

4. Press Button 3 for the ones value (the

ALARM LED will flash).

5. For example: To program the Channel

Value to 312: press Button 1 three

times, Button 2 once and Button 3

twice.

6. Press Button 12 to SAVE the value.

When Button 12 is pressed the TX

LED will flash the hundreds digit, the

ACTIVE LED will flash the tens digit

and the ALARM LED will flash the ones

digit.

JP1

7. Remove the jumper from JP3.

CB520 Programming Instructions

P/N 430489-00 Rev D

PAGE 1
Technical Document CB520 Wireless Director Call Box Programming and Install Instructions Scope This document covers all the necessary instructions for installing the CB520 Call Box and how to program the call box, using the front panel and the Status LEDs indicators. The CB520 is programmed to work with the Indyme MTS (Messaging and Telephony Server). Additional information regarding this call box can be found in TSN001- Wireless Call Boxes, Indyme part number: 435001-00.
PAGE 2
Indyme Electronics, Inc. Programming Mode and House Code. Use Button 1 to select the Mode and use Button 7 to set the House Code. When finished, use Button 12 to SAVE the programmed Mode and House code. 1. Put jumper on JP2.(JP2 is located right next to JP3) 2. Press Button 1 to select which mode. (One press for mode 1, twice for mode 2, three times for mode 3 and four times for mode 4.) 3. Press Button 7 to select which house code set. (One press for house code set 1, press twice for House Code set 2.) 4.
PAGE 3
Indyme Electronics, Inc. • Mode 4 - CU3000 Backwards Compatible Mode 4 is basically Mode 1 without Supervisory TX. This mode is backwards compatible with CU3000 systems. **Note: to work with a CU3000, the DAT file will need to be modified. Button mapping is slightly different than the CB500A.