User's Manual

ManualsBrandsIndyme Solutions ManualsElectronicsWireless Help Button

Technical Document

430735-00

Rev. D

Indyme Solutions, Inc. 8295 Aero Place  San Diego, CA 92123 USA +1.858.268.0717  +1.800.829.6141Page 1 of 4

CB461 Wireless Help Button

Programming and Installation Instructions

Overview

The CB461 is a 1-button voice assurance Help Button designed for use at Customer

Service locations. The CB461 has a dual voice assurance option designed for bi-lingual

applications. The help button must be properly programmed to communicate with a

control unit. Un-programmed help buttons default to Alarm Code 001. Triggering a help

button at this address may trigger an advisory message or trigger no message at all.

Programming a help button requires a series of button presses. The specific buttons vary

by help button type. On the CB461, SET is the “Press for Assistance” button and RESET is

a small oval below the SET button. The assurance LED is red and is located BEHIND the

SET button. This LED will flash during programming to indicate your progress.

Help Button Programming

Help buttons use a hierarchy based menu structure. You must enter the Programming Menu first, to select the

desired submenu. Each submenu may have one or more options available. These options are used to assign

specific operational characteristics to the help button. Review the submenus/options before you begin

programming. The submenus/options will vary by help button model.

Enter the Programming Menu

Press and hold the RESET button until the assurance LED flashes one time.

Press and hold the SET button, until the assurance LED flashes two times.

Press and hold the RESET button, until the assurance LED flashes three times.

The help button is now in the Programming Menu mode, proceed to the desired submenu.

The help button will automatically exit any programming menu if no buttons are pressed for 30-seconds.

Programming

Address

N/A

Operation

N/A

Menu-1

Menu-2

Menu-3

Menu-7

Menu-8

CB461

RESET

Summary of content (4 pages)

PAGE 1
Technical Document CB461 430735-00 Rev. D CB461 Wireless Help Button Programming and Installation Instructions Overview The CB461 is a 1-button voice assurance Help Button designed for use at Customer Service locations. The CB461 has a dual voice assurance option designed for bi-lingual applications. The help button must be properly programmed to communicate with a control unit. Un-programmed help buttons default to Alarm Code 001.
PAGE 2
Technical Document 430735-00 Rev. D Menu-1: Address Programming Assigns the help button to a corresponding alarm event programmed in the control unit. A help button address is a three digit number from 001 to 999. Leading zeros are required. After entering the Programming Menu; Press the SET button one time for Menu-1, RESET once to save. The assurance LED will flash one time to indicate Menu-1 was selected.
PAGE 3
Technical Document 430735-00 Rev. D INSTALLATION AND TROUBLESHOOTING TIPS 1. Identify all programming characteristics before you begin programming or installation.  Help Button Addresses  Help Button Mode  Mounting Location 2. Program the Alarm Address and Mode of each help button. 3. Install the help button in accordance with store policy, Indyme work order and/or Americans with Disabilities Act guidelines where applicable. The CB461 help button uses two 2/3A-size 3.0-volt lithium batteries.
PAGE 4
Technical Document 430735-00 Rev. D FCC and Industry Canada Notice of Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.