User's Manual

ManualsBrandsIndyme Solutions ManualsElectronicsCall Button

CB432 Programming & Install Instructions

1 P/N 430673-01 Rev B

CB432 Wireless Call Box

Programming and Install Instructions

Overview

The CB432 is a 1-button Shopper Call Box designed for use at Customer

Service locations. The CB432 has a large HELP Button designed for ease

of use in service applications. The Call Box must be properly programmed

to communicate with a control unit. Un-programmed call boxes default to

Alarm Code 001. Triggering a call box at this address may trigger an

advisory message or trigger no message at all.

Programming a call box requires a series of button presses. The specific buttons vary by call

box type. On the CB432, SET is the “large clear button in the middle” and RESET is the

“black outer casing”. The assurance LED is red and is located BEHIND the SET button.

This LED will flash during programming to indicate your progress.

Call Box Programming

Call Boxes use a hierarchy based menu structure. You must enter the Programming Menu first,

to select the desired submenu. Each submenu may have one or more options available. These

options are used to assign specific operational characteristics to the call box. Review the

submenus/options before you begin programming. The submenus/options will vary by call box

model.

Enter the Programming Menu

Press and hold the RESET button until the assurance LED flashes one time.

Press and hold the SET button, until the assurance LED flashes two times.

Press and hold the RESET button, until the assurance LED flashes three times.

The call box is now in the Programming Menu mode, proceed to the desired submenu.

(***)

Programming

Address

N/A

Operation

N/A N/A

Menu-1 Menu-2 Menu-3 Menu-7 Menu-8

CB432

RESET SET

Summary of content (4 pages)

PAGE 1
CB432 Wireless Call Box CB432 Programming and Install Instructions Overview The CB432 is a 1-button Shopper Call Box designed for use at Customer Service locations. The CB432 has a large HELP Button designed for ease of use in service applications. The Call Box must be properly programmed to communicate with a control unit. Un-programmed call boxes default to Alarm Code 001. Triggering a call box at this address may trigger an advisory message or trigger no message at all.
PAGE 2
Menu-1: Call Box Address Programming Assigns the call box to a corresponding alarm event programmed in the control unit. A call box address is a three digit number from 001 to 999. Leading zeros are required. After entering the Programming Menu; Press the SET button one time for Menu-1, RESET once to save. The assurance LED will flash one time to indicate Menu-1 was selected. Use SET and RESET to program the 3-digit address as follows; SET = digits 1-9, RESET = digit 0 and SAVE.
PAGE 3
INSTALLATION AND TROUBLESHOOTING TIPS 1. Identify all programming characteristics before you begin programming or installation. Call Box Addresses Call Box Mode Mounting Location 2. Program the Alarm Address and Mode of each call box. 3. Install the call box in accordance with store policy, Indyme work order and/or Americans with Disabilities Act guidelines where applicable. The CB432 Call Box uses two AA-size 1.5-volt alkaline batteries. Always use the same type of battery for optimum performance.
PAGE 4
5. Place the mounting holes on the back of the call box over the mounting tabs on the wall bracket; push the call box over the mounting tabs to snap in place. 6. From the final mounting location, press the SET button on the call box and verify the appropriate message is broadcast over the desired output device. Mounting Bracket Mounting Tabs Battery Compartment NOTES: (**)DO NOT use rechargeable batteries in the call box.