User's Manual

Table Of Contents

Technical Document

CB440/511 Programming and Install Instructions 1 P/N: 430223-00 Rev R

CB440/511 Programming and Installation Instructions

Determine individual call box addresses prior to starting the

installations. Un-programmed call boxes default to address 001

(Alarm Code-1). Triggering a call box at this address may trigger an

advisory message or no action at all.

Programming the CB440/CB511 Call Box Address

1. Set the internal programming jumpers for

Address Programming:

Address

Programming

Mode

Programming

Disable

Programming

CB440

JP1 OFF ON ON

CB511

JP2 OFF ON OFF

HELP = “PRESS HERE” RESET = “small white circle”

2. Press and hold RESET until the LED flashes one time. (approximately 8-seconds). The unit is now

in address programming mode.

3. The HELP and RESET buttons are used to program the 3-digit address. Leading zeros are

required. HELP = digits 1-9, RESET = digit 0 and SAVE.

4. For example, program Alarm-802 as follows:

• Press HELP 8-times, RESET once to save. (8)

• Press RESET once to represent the zero. (0)

• Press HELP 2-times, RESET once to save. (2)

Note: The LED will flash with each press of the HELP button. When the RESET button is pressed

to save the 3

digit, the LED will flash to indicate the address that was entered. The LED will

indicate digit zero by a long flash. (approximately 1-sec.)

5. Program each call box according to the mounting location.

6. Set the jumpers to “Disable” to prevent accidental changes and install the call box module.

JP1JP2

CB440/511 PCA

NOTE: In both Address and Mode programming, if no buttons are pressed for 30 seconds, the

unit will timeout and return to normal operating mode. The LED will flash five times upon

exit of either mode and any changes made will be lost.

PAGE 1
Technical Document CB440/511 Programming and Installation Instructions Determine individual call box addresses prior to starting the installations. Un-programmed call boxes default to address 001 (Alarm Code-1). Triggering a call box at this address may trigger an advisory message or no action at all. Programming the CB440/CB511 Call Box Address 1.
PAGE 2
Technical Document Mode Summary The new Call Box PCA has several different operating modes. For normal installation, each call box is programmed to mode-1 at the factory. (Standard Call Box with 8 minute LED timeout) If it becomes necessary to re-program the call box, please contact Indyme Support at 800-829-6141 for additional programming information. Location Considerations Call boxes are typically located at cash registers, service counters or other areas in which customers require assistance.