Operating Instructions COOKER GB GB Contents Installation, 2-6 English,1 Positioning and levelling Electrical connection Gas connection Adapting to different types of gas Technical data Table of burner and nozzle specifications Description of the appliance, 7 Overall view Control panel I6GG1/UK Start-up and use, 8-10 Using the hob Using the oven Oven cooking advice table Precautions and tips, 11 General safety Disposal Respecting and conserving the environment Care and maintenance, 12 Switching th
Installation ! Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe installation and operation of the appliance. The legs* fit into the slots on the underside of the base of the cooker. ! Please keep these operating instructions for future reference. Make sure that the instructions are kept with the appliance if it is sold, given away or moved.
Gas connection 700 mm T he cooker should be connected to the gas-supply by a corgi registered installer. During installation of this product it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenience of any subsequent removal or servicing. Connection of the appliance to the gas mains or liquid gas must be carried out according to the prescribed regulation in force, and only after it is ascertained that it is adaptable to the type of gas to be used.
GB or: • the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS 5733) which is accessible without moving the appliance. ! For appliances with a rating greater than 13 amp (eg: electric hob, double ovens and freestanding electric cookers etc.) the mains cable must be wired into a cooker output point with a rating of 45 amp. In this case the cable is not supplied.
Adjusting the gas oven burner’s minimum setting: ! The hob burners do not require primary air adjustment. ! After adjusting the appliance so it may be used with a different type of gas, replace the old rating label with a new one that corresponds to the new type of gas (these labels are available from Authorised Technical Assistance Centres).
GB Table of burner and nozzle specifications Table 1 Liquid Gas Burner Diameter (mm) Thermal Power kW (p.c.s.
Description of the appliance Overall view GB Gas burner Containment surface for spills Hob grid GUIDE RAILS for the sliding racks position 5 position 4 position 3 position 2 position 1 Control panel GRILL rack DRIPPING PAN Adjustable foot Adjustable foot Control panel Button for Oven Light Electronic Lighting for Hob Burners On Off Oven and Grill Control Knob Timer Knob Control Knobs for Gas Burners on Hob 7
Start-up and use GB Using the hob Flame adjustment according to levels Lighting the burners For each BURNER knob there is a complete ring showing the strength of the flame for the relevant burner. To light one of the burners on the hob: 1. Bring a flame or gas lighter close to the burner. 2. Press the BURNER knob and turn it in an anticlockwise direction so that it is pointing to the maximum flame setting E. 3.
Using the oven ! The first time you use your appliance, heat the empty oven with its door closed at its maximum temperature for at least half an hour. Ensure that the room is well ventilated before switching the oven off and opening the oven door. The appliance may emit a slightly unpleasant odour caused by protective substances used during the manufacturing process burning away. ! Before operating the product, remove all plastic film from the sides of the appliance.
GB Oven light The light may be switched on at any moment by pressing the OVEN LIGHT button. Timer To activate the Timer proceed as follows: 1. Turn the TIMER knob in a clockwise direction 4 for almost one complete revolution to set the buzzer. 2. Turn the TIMER knob in an anticlockwise direction 5 to set the desired length of time. The food must be placed on the rack in the grill pan. Position the grill pan on top of the oven rack.
Precautions and tips ! This appliance has been designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. General safety • The appliance was designed for domestic use inside the home and is not intended for commercial or industrial use. • The appliance must not be installed outdoors, even in covered areas. It is extremely dangerous to leave the appliance exposed to rain and storms.
Care and maintenance GB Switching the appliance off Inspecting the oven seals Disconnect your appliance from the electricity supply before carrying out any work on it. Cleaning the appliance Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Authorised After-sales Service Centre. We recommend that the oven is not used until the seals have been replaced. ! Never use steam cleaners or pressure cleaners on the appliance.
Removing and fitting the oven door: 6.Replace the glass. 1.Open the door 2.Make the hinge clamps of the oven door rotate backwards completely (see photo) WARNING! Oven must not be operated with inner door glass removed! GB WARNING! When reassembling the inner door glass insert the glass panel correctly so that the inscription written on the panel is not reversed and can be easily legible. 7.Replace the profile, a click will indicate that the part is positioned correctly. 8.Open the door completely. 9.
Respecting and conserving the environment GB • Whenever possible, avoid pre-heating the oven and always try to fill it. Open the oven door as little as possible because heat is lost every time it is opened. To save a substantial amount of energy, simply switch off the oven 5 to 10 minutes before the end of your planned cooking time and use the heat the oven continues to generate.
GB 15
04/2014- 195122664.00 XEROX FABRIANO GB Indesit Company S.P.A. Viale Aristide Merloni,47 60044 Fabriano (AN) www.indesit.