Key Contacts Repair Service and Information desk UK: 0870 6070805 (Open 8am to 5.30pm Mon-Fri 9am to 5pm Sat and 10am to 4pm Sun Closed bank Holidays) Instructions for installation and use Note: Our operators will require the following information:Model Number: Serial Number: Extended Warranty To join: UK 0870 442 7661 (Open Gas Built In Single Oven 8 to 8 Mon-Sun) Genuine Parts & Accessories Mail Order Hotline To join: UK 0870 558 5850 (Open 8.30 to 5 Mon-Fri and 8.
Notes If you smell gas: Do not try to light any appliance. Do not touch any electrical switch. Call the Gas Emergency Helpline at TRANSCO on: 0800 111999 In the Republic of Ireland, call the Bord Gaìs emergency line on 1850 205050 or contact your local gas supplier. The Gas Consumer Council (GCC) is an independent organisation which protects the interests of gas users. If you need advice, you will find the telephone number in your local telephone directory under Gas.
Contents Notes User Section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 23 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Be Safe - Not Sorry. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Using the Grill . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Using the Oven . . . . . . . . . . . Oven furniture . . . . . . .
Introduction We hope that the following information will help you to familiarise yourself with the features of the appliance, and to use it successfully and safely. Gas & Electrical connection Please refer to installation instructions for the Gas & Electrical Safety Regulations and the Ventilation Requirements.
Technical Data Data badge Lower part of front frame and rear of appliance. Pressure setting Cat I2H (GB/IE) Grill Nominal Rate Qn Injector Spark gap G20 @ 20mbar Introduction The cooling fan 2.4kW 1.12mm 3 - 4mm Oven Bray type burner, sheet steel body, stainless steel flame strip Gas category I2H Nominal Rate Qn Injector Spark gap Thermostat bypass Appliance class Class 3 2.5kW 1.
Introduction Glass door panels To replace a light bulb (if fitted) To meet the relevant Standards of Domestic cooking appliances, all the glass panels on this appliance are toughened to meet the fragmentation requirements of BS3193. This ensures that, in the unlikely event that a panel breaks, it does so into small fragments to minimise the risk of injury. Caution: Switch off the electricity supply to the appliance, to avoid the possibility of electric shock.
Installation Instructions Step 4: Check edging strip Step 5: Secure appliance into housing unit The edging strip is factory fitted to the front side edges of the appliance front frame. This strip provides the cabinetry with extra protection from any escape of heat. There are 4 black no 8 x 25mm long chipboard screws for securing appliance to cabinet. Insert appliance into cabinet and secure - open the oven door and screw the 4 screws through the holes in the front frame.
Using the Grill Caution: Accessible parts may be hot when the grill is used, young children should be kept away. Installation Instructions Detachable grill pan handle trivet Step 3: Connect to the electricity supply As the colours of the wires in the mains lead for the appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: Warning: This appliance must be earthed.
Installation Instructions Step 2: Connect to gas supply 4. Flexible connections should be to BS669. Parts of the appliance likely to come into contact with a flexible connector have a temperature rise less than 70°C. 1. The inlet to the appliance is ISO 7 - Rp 1⁄2” internal thread situated towards the top right hand rear corner. 5. Parts of the cooker likely to come into contact with the flexible hose have a temperature rise less than 70˚C. 2.
Using the Oven When you are cooking, keep children away from the vicinity of the oven. In the event of the burner flames being accidentally extinguished, turn off the burner control and do not attempt to re-ignite the burner for at least one minute. Oven ignition If it is found over a period of time that the oven becomes hotter when used at a particular gas mark, the thermostat may need to be replaced. Push in and turn the oven control knob anticlockwise to gas mark 9.
Installation Instructions Step 1: Prepare installation 90 Do not lift the appliance by the door handle. Using the Oven Oven furniture mm (mi n imu m) The oven shelf must be positioned with the upstand facing upwards. Whilst every care is taken to eliminate burrs and raw edges from this product, please take care when handling - we recommend the use of protective gloves during installation. Please note that the weight of this appliance is approximately 31kg (unpacked).
Using the Oven Cooking frozen & chilled foods ● Preheat the oven. Slow cooking ● When cooking frozen or chilled foods, please follow the manufacturer’s instructions. If cooking more than one tray or item, cooking times may need to be increased. ● Make sure that frozen foods are thoroughly THAWED before cooking. ● Do not slow cook joints of meat or poultry weighing more than 21⁄4 kg / 41⁄2lb. ● Please ensure that foods are piping hot before consumption.
Cleaning Using the Oven Traditional fruit cakes Roast turkey Only use a clean cloth wrung out in hot soapy water, and dry with a soft cloth. It should be remembered that ovens can vary over time, therefore cooking times can vary, making it difficult to be precise when baking fruit cakes. Stubborn marks can be removed using “Luneta”. We recommend that you clean the whole of the stainless steel area to maintain a uniform finish. Supplies can be purchased from the Customer Care Centre.
Using the Oven Cleaning Glass parts 7 “S” (slow setting) top to middle middle to bottom 8 - 15 mins 2 - 3 hours 5 5 6 4 middle middle middle middle 15 20 10 20 4 3 3 2 or 3 middle middle to top middle to top middle to top 20 - 30 mins 1 - 11⁄4 hours 1 - 11⁄4 hours 21⁄2 - 3 hours 1 or 2 middle to bottom 3 middle to bottom depending on recipe 2 - 21⁄2 hours Pastry Flaky / Puff Shortcrust Choux Plate tarts 7 6 6 6 middle middle middle middle to to to to top top top top 15 15 15 30 Biscuit
Cleaning Using the Oven Vitreous enamel parts Caution: Any cleaning agent used incorrectly may damage the appliance. GRILL Always let the appliance cool before cleaning. Use a mild cream cleaner - eg; “Cif”. OVEN SHELVES & OVEN SHELF RUNNERS, GRILL PAN TRIVET Do not use abrasives or polishes. Use a moist soap pad - eg; “Brillo”. Shelf runners can be removed for cleaning. Grasp the runners, and slide out of the hanging holes as shown. Note: These items may also be cleaned in a dishwasher.
Using the Oven Automatic cooking Do not: The automatic cooking facility is controlled by the programmer (see ‘Programmer/ Clock’ section) and allows complete meals, or individual dishes to be cooked while you are out of the house, to be ready for when you return. The ‘Ready Time’ should be set as close as possible to, or just after your anticipated return so food is not left standing in a warm oven. ■ Warm food should never be placed in the oven if there is a delay period.
Programmer / Clock Using the Oven Important: Food is more susceptible to the growth of food poisoning organisms in warm conditions. If the weather is hot, either take care to ensure that food is not left standing in a warm oven, or avoid using the automatic cooking facility. 5. Auto symbol appears. Fully automatic cooking (example) For use when a delayed start time is required. A U T O You want to set the length of cooking time, and the time for the oven to switch off.
Programmer / Clock The programmer buttons minute minder cook time ready time manual minus plus Manual operation Programmer / Clock Semi-automatic cooking (example) 1. Auto symbol appears. You have started cooking a meal or dish in the oven, and want to set the time for the oven to switch off. To set the programmer to manual operation at any time (cancelling any automatic setting), press the manual button. The programmer must be set to manual before the appliance can be used manually.