Setup and user guide

ManualsBrandsIndesit ManualsDishwashersDFG 15B1 S IT

DAILY REFERENCE

GUIDE

Before using the appliance carefully read Health and Safety guide.

APPLIANCE

PRODUCT DESCRIPTION

CONTROL PANEL

0000 000 00000

Service:

1. Upper rack

2. Foldable aps

3. Upper rack height adjuster

4. Upper spray arm

5. Lower rack

6. Cutlery basket

7. Lower spray arm

8. Filter Assembly

9. Salt reservoir

10. Detergent and Rinse Aid dispensers

11. Rating plate

12. Control panel

THANK YOU FOR BUYING A INDESIT PRODUCT.

In order to receive a more complete assistance, please

www.indesit.com

You can download the Safety Instructions and the

Use and Care Guide, by visiting our website

docs.indesit.eu and following the Instructions on

the back of this booklet.

1. On-O/Reset button

2. Program selection knob

3. Start/Pause button with indicator ligh

4. Indicator light Washing

5. Indicator light Drying

6. Indicator light Wash Cycle Complete

7. Salt rell indicator light

5467

Summary of content (8 pages)

PAGE 1
EN DAILY REFERENCE GUIDE THANK YOU FOR BUYING A INDESIT PRODUCT. In order to receive a more complete assistance, please register your appliance on: www.indesit.com You can download the Safety Instructions and the Use and Care Guide, by visiting our website docs.indesit.eu and following the Instructions on the back of this booklet. Before using the appliance carefully read Health and Safety guide. PRODUCT DESCRIPTION APPLIANCE 1 7 2 8 3 9 4 5 6 11 10 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12.
PAGE 2
FIRST TIME USE SALT, RINSE AID AND DETERGENT ADVICE REGARDING THE FIRST TIME USE After installation, remove the stoppers from the racks and the retaining elastic elements from the upper rack. FILLING THE SALT RESERVOIR The use of salt prevents the formation of LIMESCALE on the dishes and on the machine’s functional components. • It is important that the salt reservoir be never empty. • It is important to set the water hardness.
PAGE 3
EN Drying PROGRAMS TABLE Program Detergent container Tub B Duration of wash program (h:min)*) Water consumption (litres/cycle) Energy consumption (kWh/cycle) 3:20 12 1,04 1 Eco 50° 2 Intensive 65° - 2:30 15,0 1,50 3 Normal 55° - 2:00 15,0 1,35 4 Rapid 40’ 50° - - 0:40 9,0 0,90 - - - 0:10 4,5 0,01 5 Soak - ECO program data is measured under laboratory conditions according to European Standard EN 50242.
PAGE 4
DAILY USE 1. CHECK WATER CONNECTION Check that the dishwasher is connected to the water supply and that the tap is open. MODIFYING A RUNNING PROGRAM 3. LOAD THE RACKS (see LOADING THE RACKS). If a wrong program was selected, it is possible to change it, provided that it has only just begun: press and hold the ON/OFF button, the machine will switch off.
PAGE 5
EN LOADING THE RACKS UPPER RACK LOWER RACK Load delicate and light dishes: glasses, cups, saucers, low salad bowls. For pots, lids, plates, salad bowls, cutlery etc. Large plates and lids should ideally be placed at the sides to avoid interferences with the spray arm.
PAGE 6
CARE AND MAINTENANCE CLEANING THE FILTER ASSEMBLY CLEANING THE SPRAY ARMS Regularly clean the filter assembly so that the filters do not clog and that the waste water flows away correctly. The filter assembly consists of three filters which remove food residues from the washing water and then recirculate the water: to obtain the best washing results, you need to keep them clean. The dishwasher must not be used without filters or if the filter is loose.
PAGE 7
EN TROUBLESHOOTING Your dishwasher may not work properly. Before contacting the Service Centre check if the problem can be solved by going through the following list. PROBLEMS POSSIBLE CAUSES SOLUTIONS The dishwasher won’t start or does not respond to commands. The appliance has not been plugged in properly. Power outage. Insert the plug into the socket. The dishwasher door is not closed. Vigorously push the door until you hear the “click”. It does not respond to commands.
PAGE 8
400011309121 10/2018 jk - Xerox Fabriano 8