Dishwasher Instructions for installation and use DE 73
DE 73 Dishwasher Installation and use
Safety Is a Good Habit to Get Into NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance. 6.This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof; it is also very dangerous to leave it exposed to the rain and elements. 7.Do not touch the heating element during or after a wash cycle.
Close-up View (control panel) B M I Intensive Normal After dinner Delicates 55 50 Rapid Hot rinse H E F D Soak 25 70 55 1 45 Reset 2 7 3 S 4 6 5 A C GB N L G ON-OFF Button Cycle phase underway indicator ON-OFF Indicator light Delayed start indicator light Door opening handle Button for selection Upper or Lower Rack Delayed start setting button Multifunction numeric indicator Low salt indicator light M Cycle selection knob Low rinse aid indicator light N Racks indicato
Close-up View (Interior) E G F H J I K L Bottom Sprayer Arm Upper Rack Salt Container Cap Top Sprayer Arm Washing Filter Rack Height Adjustor Detergent and Rinse Aid Dispenser Lower Rack Technical characteristics Width cm. 60 Depth cm. 60 Height cm.
Salt ...... Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loading the Salt into the Softener Always use salt intended for use with dishwashers. The salt container is located beneath the lower rack and should be filled as follows: 1.
Detergent and Rinse Aid .... Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table." The detergent dispenser is located on the inside panel of the door. Loading the detergent To open lid "A", press button "B". The cleaning detergent should be introduced into the two containers "C"and "D" up to the rim.
Loading the Dishwasher How to Use the Lower Rack We recommend that you place the most difficult to clean items on the bottom rack: pots, pans, lids, serving dishes and bowls, as shown in the figure to the right. It is preferable to place serving dishes and lids on the sides of the racks in order to avoid blocking the rotation of the top spray arm. - Pots, serving bowls, etc. must always be placed top down. - Deep pots should be slanted to allow the water to flow out.
Turning on the Appliance How to start a wash cycle… After performing all the operations described in the previous chapters, turn the water tap on completely, press ON-OFF button "A" situated on the control panel, indicator light "B" comes on. The display turns on and the 3 dashes appear, indicating that the dishwasher is awaiting instructions. Starting and setting the cycle.
Dishwasher delayed start programming Dishwasher delayed start programming Wash cycle modification buttons Premise: before selecting a wash cycle as indicated in the paragraph entitled "Starting and setting a wash cycle…", a delayed start can be set. Press button "D" (see close-up view "control panel") to delay the start of a wash cycle by 1 to 24 hours.
Wash Cycle Table Cycle Cycle selection instructions Very dirty dishes and pans (not to be used for delicate items). 1) Intensiv 2) Normal (IEC-EN 50242) 3) After Dinner Cycle description Pre-wash with cold water Pre-wash with hot water at 45°C. Extended wash at 70°C. 1 rinse with cold water. Hot rinse at 70°C. Drying. Normally dirty pans and dishes. Standard daily cycle. 2 pre-washes with cold water. Extended wash at 55°C. Hot rinse at 70°C. Drying.
Energy Saving Tips - It is important to try and run the dishwasher when it is fully loaded in order to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the hold cycle. - Choose the right wash cycle: the choice of cycle depends on the type of dishware, cookware and utensils being washed and how dirty they are.
Cleaning and Special Maintenance Filter Assembly For best performance and results, the filter assembly must be cleaned . The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the "A" semi-circular filter and cup under running water. To remove the filter assembly, pull on the cup handle in the upward direction.
Installation Positioning the Appliance Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation. This dishwasher model can be built-in under the one worktop, and it therefore comes provided with an assembly kit complete with an instructions sheet.
Electrical Connection Electrical Connection If your appliance is supplied with a 13 amp. fused plug it can be plugged into a 13 amp socket for immediate use. Before using the appliance please read the instruction below. WARNING: THIS APPLIANCE MUST BE EARTHED. THE FOLLOWING OPERATIONS SHOULD BE CARRIED OUT BY A QUALIFIED ELECTRICIAN. Replacing the fuse: When replacing a faulty fuse, a 13 amp ASTA approved fuse to BS 1362 should always be used, and the fuse cover re-fitted.
Merloni Elettrodomestici 10/00 - 195028034.00 - Xerox Business Services - DocuTech Viale Aristide Merloni 47 60044 Fabriano Italy Tel +39 0732 6611 Fax +39 0732 662501 www.merloni.