Notice d’utilisation et installation SÈCHE-LINGE GB Table des Matières English, 15 Informations Importantes, 2-3 F Français, 1 Installation, 4 Où installer votre sèche-linge Ventilation Instructions d’inversion de la porte Vidange de l’eau Connexions électrique Avant de commencer à utiliser votre sèche-linge Description du sèche-linge, 5 Pour ouvrir la porte Caractéristiques Panneau de commandes Démarrage et programmes, 6-8 ALE700CX Choisir un programme Tableau des programmes Les commandes Linge,
Informations Importantes F Pour que votre sèche-linge à condenseur fonctionne efficacement, vous devez suivre le programme d’entretien courant décrit ci-dessous: Filtre... ! Vous devez IMPERATIVEMENT nettoyer le filtre à peluches A CHAQUE cycle de séchage. ETAPE 1. Ouvrez la porte du sèche-linge. ETAPE 2. Sortez le filtre (à l'aide des deux encoches passe-doigts) ETAPE 3. Enlevez les dépôts de peluches des mailles du filtre. ETAPE 4.
Informations Importantes Groupe condenseur... F ! Vous devez IMPERATIVEMENT enlever les peluches du condenseur TOUS LES MOIS. ETAPE 1. Ouvrez le couvercle du condenseur - tenez la poignée et tirez vers vous. ETAPE 2. Retirez le condenseur en tournant les 3 agrafes et en le tirant vers vous. (Les tubes peuvent contenir un peu d’eau ; ceci est normal). ● ETAPE 3. Rincez le condenseur par l’arrière avec de l’eau pour enlever les dépôts de peluches. ETAPE 4.
Installation F Où installer votre sèche-linge Vidange de l’eau Placez votre sèche-linge à une certaine distance des cuisinières, fourneaux, radiateurs, ou plaques de cuisson à gaz, car les flammes peuvent endommager cet appareil.
Description du sèche-linge Pour ouvrir la porte Caractéristiques Appuyez et relâchez le panneau avant dans la position indiquée F Réservoir d’eau Plaque signalétique Numéro du Modèle et Numéro de Série Groupe condenseur (couvercle ouvrir) Couvercle de condenseur Poignée de couvercle de condenseur (Tirer ou ouvrir) Panneau de commandes Bouton MARCHE/ARRÊT Boutons et Témoins OPTION Bouton PROGRAMMES Le bouton MARCHE/ARRÊT : si le sèche-linge fonctionne et qu’on appuie sur ce bouton, le sèche-linge s
Démarrage et Programmes F Choisir un programme 1. Branchez la fiche du sèche-linge dans la prise électrique. 2. Triez votre linge en fonction du type de textiles (voir Linge). 3. Ouvrez la porte et en assurant-vous que le filtre soit propre et en place et le réservoir d’eau est vide et en place (voir Entretien). 4. Chargez la machine et assurez-vous que des articles ne bloquent pas le joint de la porte. Fermez la porte. 5. Si aucan des voyanta n’est allumé : appuyez sur le bouton MARCHE/ARRET 6.
Démarrage et Programmes Programmes F ! Si aucun des voyanta n’est allumé; appuyez sur le bouton MARCHE/ARRÊT et sélectionnez ensuite le programme. Programme Ce qu’il fait... Cotons Sèche vos vêtements sur le 1. Positionnez le bouton des PROGRAMMES sur réglage Température Élevée, 2. Sélectionnez des Options, si nécessaire. prêts à porter. 3. Appuyez sur le bouton de DÉPART/PAUSE Séchage ultra Comment le régler...
Démarrage et Programmes Les commandes F Bouton des PROGRAMMES ! Attention, si après avoir appuyé sur le bouton de Départ/Pause , la position du bouton des programmes a changé, cette nouvelle position NE changera PAS le programme sélectionné. ● Pour modifier un programme sélectionné, appuyez sur le bouton Départ/Pause . Le témoin clignote en orange pour indiquer que le programme est suspendu. Sélectionnez le nouveau programme et les éventuelles options nécessaires. Le témoin clignote alors en vert.
Linge Trier votre linge Étiquettes d’Entretien Vérifiez les symboles sur les étiquettes des vêtements pour vous assurer que les articles peuvent être passés au sèche-linge. ● Triez votre linge par type de textile. ● Videz les poches et vérifiez les boutons. ● Fermez les fermetures Éclair et les crochets et attachez les ceintures et les cordons. ● Essorez chaque article de manière à éliminer autant d’eau que possible. ! Ne chargez pas de vêtements mouillés qui dégouttent dans le sèche-linge.
Linge F Vêtements spéciaux Ces temps sont approximatifs et peuvent varier en fonction des paramètres suivants : Les Couvertures et Dessus de lits : articles en acrylique (Acilan, Courtelle, Orion, Dralon) doivent être séchés avec des précautions particulières, à BASSE température. Évitez de les sécher pendant une durée prolongée. Vêtements plissés ou froissés : lisez les instructions de séchage du fabricant figurant sur le vêtement.
Avertissements et Suggestions ! Cet appareil a été conçu et construit conformément à des normes de sécurité internationales. Ces avertissements sont donnés pour des raisons de sécurité et doivent être suivis attentivement.
Entretien et Nettoyage F Éteignez l’électricité Nettoyage du tambour ! Débranchez votre sèche-linge lorsque vous ne l’utilisez pas, lorsque vous le nettoyez et durant toutes les opérations d’entretien. ! Pour nettoyer le tambour, ne pas utiliser d’abrasifs, de laine d’acier ni de produits de nettoyage pour acier inoxydable. Nettoyez le filtre après chaque cycle Un film coloré peut parfois apparaître à la surface du tambour en acier inoxydable.
Que faire en cas de panne Votre sèche-linge semble ne pas fonctionner. Avant d’appeler votre Centre de Service d’Entretien (voir Service d’Entretien), passez en revue les suggestions de dépannage suivantes : Problème : Le sèche-linge ne démarre pas. Causes possibles / Solution : ● ● ● ● ● ● ● Le cycle de séchage ne démarre pas. L’appareil met longtemps à sécher. ● ● ● ● ● ● ● ● ● Le témoin “Vider l’Eau” clignote mais le sèche-linge n’a fonctionné que pendant une courte période.
Service Après-Vente F Avant d’appeler le Centre de Service Après-Vente : Utilisez le guide de dépannage pour voir si vous pouvez résoudre le problème vous-même (voir Que faire en cas de panne). Si non, éteignez le sèche-linge et appelez le Centre de Service Après-Vente le plus proche. ● ● Quelles informations donner au Centre de Service Après-Vente : ● Vos nom, adresse et code postal. ● Votre numéro de téléphone. ● Le type de problème. ● La date d’achat. ● Le modèle de l’appareil (Mod.).
Instruction booklet TUMBLE DRYER GB Contents English, 15 Important Information, 16-17 F Français, 1 GB Installation, 18 Where to put your dryer Ventilation Door reversal instructions Water drain Electrical connection Before you start using your dryer Dryer description, 19 To open the door The features Control panel Start and programmes, 20-22 ALE700CX Choosing a programme Table of programmes The controls Laundry, 23-24 Sorting your laundry Wash care labels Special clothing items Drying times Wa
Important Information GB For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below: Fluff Filter... ! You MUST clean the fluff filter after EVERY drying cycle. STEP 1. Open the door of your dryer. STEP 2. Pull out the filter (using the two finger grips). STEP 3. Clean any fluff deposits from the filter mesh. STEP 4. Refit the filter - NEVER run the dryer without the filter in position.
Important Information Condenser Unit... GB ! You MUST clean the fluff from the condenser EVERY month. STEP 1. Open the condenser cover - hold the handle and pull towards you. STEP 2. Remove the condenser by rotating the 3 clips then pulling the condenser towards you. (There may be some water in the tubes, this is normal). ● STEP 3. Flush the condenser, from the rear with water, to remove any fluff deposits. STEP 4.
Installation GB Where to put your dryer Water drain Place your dryer at a distance from gas ranges, stoves, heaters, or cook tops because flames can damage the appliance. ● Minimum gap 10mm If you are going to install the appliance under a work counter, be sure to leave a 10mm space between the Minimum gaps top and any other objects 15mm on or above the machine and a 15mm space between the sides and lateral furnishings or walls. This is to ensure proper air circulation.
Dryer Description To open the door The features Water container Press and release the front panel in position shown GB Rating plate Model & Serial numbers Condenser unit (Cover open) Condenser cover Condenser cover handle (Pull to open) Air intake grille Filter Control panel PROGRAMMES Knob Indicator Drying Guide ON/OFF Button The ON/OFF button : If the dryer is running and this button is pressed, the dryer stops. Press again, the dryer restarts.
Start and Programmes GB Choosing a programme 1. Plug the dryer into the electrical socket. 2. Sort your laundry according to fabric type (see Laundry). 3. Open the door and make sure the filter is clean and in place and the water container is empty and in place (see Maintenance). 4. Load the machine and make sure items are not in the way of the door seal. Close the door. 5. If none of the lights are on: Press the ON/OFF button . 6.
Start and Programmes Programmes GB ! If none of the lights are lit; Press the ON/OFF button and then select programme. Programme What it does... Options available: Cottons Dries your clothes on High Heat 1. Position the PROGRAMMES knob on 2. Select any options if required. setting, ready for wearing. 3. Press the START/PAUSE button (Départ/Pause) Dries your clothes on High Heat 1. Position the PROGRAMMES knob on setting, ready for putting away. 2. Select any options if required. 3.
Start and Programmes The Controls GB ● PROGRAMMES knob ! Warning, if after pressing the START/PAUSE button (Départ/Pause) , the programmes knob position has changed, the new position will NOT change the programme selected. To change a selected programme, press the START/PAUSE button (Départ/Pause) ,the light flashes Amber to indicate the programme is paused. Select the new programme and any options required, the light will then flash green.
Laundry Sorting your laundry Wash Care Labels Check symbols on clothing labels to make sure that the articles can be tumble dried. ● Sort laundry by fabric type. ● Empty pockets and check buttons. ● Close zippers and hooks and tie loose belts and strings. ● Wring out each item in order to eliminate as much excess water as possible. ! Do not load dripping wet clothes into the dryer. Look at the labels on your garments, especially when tumble drying for the first time.
Laundry GB Special clothing items Times are approximate and can vary depending upon: Blankets and Bedspreads: acrylic items (Acilan, Courtelle, Orion, Dralon) must be dried with special care on LOW heat setting. Avoid drying for a long period of time. ● ● Pleated or creased garments: read the manufacturer’s drying instructions on the garment. Starched articles: do not dry these with non-starched items.
Warnings and Suggestions ! The appliance has been designed and built according to international safety standards. These warnings are given for safety reasons and must be followed carefully.
Maintenance and Care GB Switching off the electricity Cleaning the drum ! Unplug your dryer when not using it, when cleaning it and during all maintenance operations. ! Do not use abrasives, steel wool or stainless steel cleaning agents to clean the drum. Clean the filter after each cycle The filter is an important part of your dryer: it accumulates lint and fluff that is formed while drying. When finished drying, clean the filter by rinsing it under running water or with your vacuum cleaner.
Troubleshooting One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the following troubleshooting suggestions: Problem: Possible causes / Solution: The tumble dryer won’t start. ● ● ● ● ● ● ● Drying cycle will not begin. ● Its taking a long time to dry. ● ● ● ● ● ● ● ● Empty water light is flashing but the dryer has only been running for a short period. Empty water light is on and the water container is not full.
Service 195064281.00 W 07/2007 - SIMLEX . Four Ashes, Wolverhampton GB Before calling the Service Centre: Use the troubleshooting guide to see if you can solve the problem yourself (see Troubleshooting). If not, turn off the dryer and call the Service Centre closest to you. ● ● What to tell the Service Centre: name, address and post code. ● telephone number. ● the type of problem. ● the date of purchase. ● the appliance model (Mod.). ● the serial number (S/N).