User guide

www.incra.com

Manufactured by:

Taylor Design Group, Inc.

P.O. BOX 810262 Dallas, TX 75381

P: 972-242-9975 www.incra.com

INCRA Tools are protected by one or more of the following US patents:

#4,793,604, #4,930,221, #5,195,730, #5,275,074, #5,423,360, #5,716,045, #6,237,457,

#6,557,601, #6,672,190. rev.04.17.13

INCRA is a Registered Trademark of Taylor Design Group

INCRA Miter Channel

Glue Down Instructions

MADE IN THE

USA

Cut a 1-1/8” wide x 1/2” deep groove in

your application.

Apply a bead of heavy duty construc-

tion adhesive like Liquid Nails

Use a putty knife or chisel to atten the

bead.

You can also consider “Surface Mount” or “Build-up” options for mounting as shown below.

Surface Mount

Adhere INCRA Miter Channel directly to the application.

Build-up

Use a 1/2” thick material on either side of a surface

mounted INCRA Miter Channel.

As an alternative, you can drill and countersink mounting

holes in your INCRA Miter Channel and mount to your appli-

cation using #8 at head screws. Drill the holes with a .219”

diameter standard twist drill bit then countersink to a depth

that brings the top of the fastener head just below the surface

of the extrusion.

PAGE 1
w w w. i n c r a . c o m INCRA Miter Channel Glue Down Instructions Cut a 1-1/8” wide x 1/2” deep groove in your application. Apply a bead of heavy duty construction adhesive like Liquid Nails®. Use a putty knife or chisel to flatten the bead. You can also consider “Surface Mount” or “Build-up” options for mounting as shown below. Surface Mount Build-up Adhere INCRA Miter Channel directly to the application. Use a 1/2” thick material on either side of a surface mounted INCRA Miter Channel.