“SPECIAL EDITION” Telescoping Fence Addendum Your new “Special Edition” INCRA Miter Gauge now includes a telescoping fence and Flip Shop Stop. These upgrades replace the fence and stop described in the owners’s manual. Follow the steps below to set up and use your telescoping fence. 1 Attach Fence to Miter Gauge FIG. 1 1⁄ 4-20 X 1⁄ 2” SOCKET HEAD SCREWS Using the (2) 1⁄ 4 -20 x 1⁄ 2” socket head screws with washers and rectangular nuts, attach the fence to the fence mounting bracket.
Flip Shop Stop Instructions Introduction As you look at your new Incra Flip Shop Stop and fence for the first time you will no doubt see a most interesting detail. The front face of the fence uses a tongue and groove arrangement to accept a mating feature on the flip arms. When the flip arm is down with the two opposing tongue and grooves engaged, it becomes impossible for the sharp corner of a mitered board end to wedge between the fence and flip arm.
Flip Arms and Stop Rods The dual flip arms and stop rods provided permit a variety of stop configurations. The flip arms can be used without the stop rods when you want to take advantage of the fence/arm tongue and groove feature for stop control on mitered board ends. Typically you will use the longer rod to join the two arms together. Fig 5. This produces an arrangement that, when pivoted, moves both arms simultaneously.