MW153 TW153 Specification Product Name Bluetooth BoomBox Model Number MW153 TW153 Brands: Memorex (MW153), TDK Life on Record (TW153) Document Initiated June 1, 2012
Control Map
Control Panel Display 1. Factory Settings Volume should be set to 30-%40 of max volume Source selection will be set to “Line-In.” 2. Power On To power on device, Press POWER button. LED in volume button will illuminate (white) when the device is powered on. The device will power-up into whichever source mode it was powered down. 3. Power Off To power off, press POWER button. 4.
5. Adjust Volume Increase volume by pressing VOLUME + Decrease volume by pressing VOLUME – 6. Line-In Source Press AUX button to switch to line-in source. When in Line-In source, display audio visualizer. Visualizer is a function of volume signal strength to left and right channels. 7. Bluetooth Press BLUETOOTH button once to engage Bluetooth mode. Will connect to previously connected devices if possible. Press and hold BLUETOOTH button for 3 sec to make MW153/TW153 is discoverable to compatible devices.
8. Bluetooth Connections Bluetooth connection will not terminate when switch between Bluetooth and Line-In. MW153/TW153 will send “pause” signal to streaming device when switching between Bluetooth and LineIn mode. 9. Returning Connections When powered on and in Bluetooth source mode, MW153/TW153 will automatically connect to the most recently paired device if it is available. 10. Headphone When using headphones, audio does not stream from speakers. 11.
15. Presets There are six preset stations available. To set a preset in slot (one), tune to desired station. Press and hold PRESET button. After 1 second of holding, preset (#1) Icon will begin flashing. Release button to set station. To set stations 2-6, press and hold PRESET button until the desired preset begins to flash. Pressing preset button once will tune to preset number 1. Press again to tune to number 2 etc. Preset number will appear on display for 2 seconds, and then display tuned station.