User's Manual

U ser

ser

ser M

M anual

anual

1. Buttons and Connections

2. Charging with InCharge Auto BT

2.1 Charging an iPod / iPad / iPhone

i. When you plug the CLA into the 12V in a Car, The Orange LED will turn on, to show that the CLA

is being powered.

ii. When a USB Device is plugged into the CLA, up to 2.1A of power will be supplied immediately.

3. Connecting to Bluetooth

3.1 Connecting to InCharge Auto BT via Bluetooth

i. Hold down the ʻ Call ʼ button for 2 seconds, this will allow the Bluetooth device to be discovered.

ii.

The Orange LED will turn off and LED will begin to slowly Flash Blue.

iii. Then, the User selects "InCharge Auto BT" from the Bluetooth List on their device. If the device

requires a pairing code, use "0000".

iv. O nce the device has successfully paired, there will be an audible ʻ beep ʼ sent to the stereo and the

LED will stop flashing and stay solid blue.

v. If the unit is not paired after three minutes, the LED will stop flashing blue and it will become solid

orange

vi.

InCharge Auto BT will remember the device that it is paired with, and link to it each time that InCharge

Auto BT is powered on and the device is in range.

Playing Audio over Bluetooth

4.1 Playing wireless Audio over Bluetooth

i. The user must have their radio set to AUX and the 3.5mm cable properly connected.

ii. Press the ʻ call ʼ button on the 3.5 Jack, this will send a play command to the iPod

iii. The music will start playing as quickly as possible.

iv. The ʻ call ʼ button can be pressed at anytime to pause or play the audio.

PAGE 1
User Manual 1. Buttons and Connections 2. Charging with InCharge Auto BT 2.1 Charging an iPod / iPad / iPhone i. When you plug the CLA into the 12V in a Car, The Orange LED will turn on, to show that the CLA is being powered. ii. When a USB Device is plugged into the CLA, up to 2.1A of power will be supplied immediately. Connecting to Bluetooth 3. 3.1 Connecting to InCharge Auto BT via Bluetooth i. Hold down the ʻCallʼ button for 2 seconds, this will allow the Bluetooth device to be discovered. ii.
PAGE 2
User Manual 5. Receiving a call via Bluetooth 5.1 Receiving a call via Bluetooth i. If audio is playing over Bluetooth, the audio volume will dim and the phone will ring over the car stereo. ii. Press the ʻcallʼ button on the 3.5 Jack to answer a call. The Audio from the call will begin to play over the car stereo, The Microphone on the 3.5 jack will be the active microphone. iii.