IMAGIC IMAGIC IM-3K01 Develop Guide Ver_1.0.0 FCC ID:2AMI2-IM-3K01 IC:22853-IM3K01 IMAGIC IM-3K01 Develop Guide Version: Ver_1.0.
IMAGIC IMAGIC IM-3K01 Develop Guide Ver_1.0.0 Contens Module photo ................................................................................................................................... 1 Specifications .................................................................................................................................... 1 Pin Definitions ..................................................................................................................................
IMAGIC IMAGIC IM-3K01 Develop Guide Ver_1.0.0 Module photo P.1 Module photo Specifications Specifications WIFI IEEE 802.
IMAGIC IMAGIC IM-3K01 Develop Guide Ver_1.0.0 Function Remarks A1 ADC1 GPIO A2 ADC2 GPIO A3 ADC3 GPIO A4 ADC4 GPIO A5 GPIO25 GPIO A6 GPIO26 GPIO A7 GPIO27 GPIO A8 GPIO14 GPIO A9 GPIO12 GPIO A10 GPIO13 GPIO B1 GPIO15 GPIO B2 GPIO2 GPIO B3 GPIO0 power-up must be pin floating or Pull-up NO A B When Pull-down, operating in the Download mode. B4 GPIO4 GPIO B5 GPIO16 GPIO B6 GPIO17 GPIO C1 VDD_33 power supply , 3.
IMAGIC IMAGIC IM-3K01 Develop Guide Ver_1.0.0 C9 GPIO18 GPIO C10 GPIO5 GPIO Reference circuit 1. PA antenna circuit 2.Flash 3.
FCC statements: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or changes to this equipment.
This device is intended only for OEM integrators under the following conditions: 1. The antenna must be installed such that 20 cm is maintained between the antenna and users. 2. The transmitter module may not be co-located with any other transmitter or antenna. As long as the two conditions above are met, additional transmitter testing will not be required.
Cet appareil est conçu uniquement pour les intégrateurs OEM dans les conditions suivantes: (Pour utilisation de dispositif module) 1. L'antenne doit être installée de telle sorte qu'une distance de 20 cm est respectée entre l'antenne et les utilisateurs. 2. Le module émetteur peut ne pas être coïmplanté avec un autre émetteur ou antenne. Tant que les deux conditions ci-dessus sont remplies, des essais supplémentaires sur l'émetteur ne seront pas nécessaires.