User's Manual

1, Power On

Press and Hold Multifunction button 1 Second , promotes " Power On" , LED lights up , unit

goes into Discovering mode, Blue LED switch to fast flashing ( 2times /s)

2, Pairing

Press and Hold Multifunction button 3 Seconds comes from Speaker then promotes " ready to pair

", unit goes into "Pairing" mode, Blue LED switch to Blue/Red flashing alternately ( 2times /s) .A

voice prompt when pairing success (pairing complete)

3, Connect to device

Touch and click Headset name in device blue tooth setting menu, Speaker then promotes " device

connected" , unit paired sucessfuly , Blue LED switch to slow flashing ( 4seconds /time)

4, Playing Music

1). If Music player app opened, after paired with speaker , Music start play directly

2). On paired mode, Open apps , Press multifunction button on headset to start play, Press again,

Pause playback.

3). Press and Hold“VOL+”button, skip to next song, Press and Hold“VOL-”button go back to last

song.

4). Press “VOL+/VOL-”button repeatedly to adjust volume ,Volume will go to maximum or

minimum ,and a voice prompt"minimum volume/maximum volume"

5, Incoming call, hand free

1). When incoming call received ,he phone ringing or voice prompt"incoming call " , LED

switch to fast flashing 2 times/second

2). When incoming call received , Press and Multifunction button to pick up ,Speaker then

promotes "call ended" Blue LED switch to slow flashing ( 1time /s), Press the same button again

to hang up.

3). During hand free conversation , During hand free conversation , Press and Hold

“VOL-”button to mute the sounds , Press and Hold “VOL-”button to cancel mute and go back

conversation

4). During hand free conversation Press “ VOL+/VOL- ” button repeatedly to adjust

volume ,Volume will go to maximum or minimum ,and a voice prompt"minimum

volume/maximum volume）

5). Double click multifunction button , Redial the last dialed number, voice prompt:（last number

redial）

6, Refused to call

When incoming call received, Press and Hold multifunction button 1 second Drip hint sound

comes from speaker and voice prompt"calling rejected"

7, Three-party conference(This function only applies to the current paired device and

Communication operators support )

In case conference is on, another call is incoming :

PAGE 1
, Power On Press and Hold Multifunction button 1 Second , promotes " Power On" , LED lights up , unit goes into Discovering mode, Blue LED switch to fast flashing ( 2times /s) 2, Pairing Press and Hold Multifunction button 3 Seconds comes from Speaker then promotes " ready to pair ", unit goes into "Pairing" mode, Blue LED switch to Blue/Red flashing alternately ( 2times /s) .
PAGE 2
1).Double click multifunction button to hang up current call and pick up new incoming call; 2). Short press multifunction button to pick up new call also keep current conference 3). Short press multifunction button to Switch new and current conference call 8, Call conference transferring between mobile phone and bluetooth headset On call conference, press and Hold multifunction button 1 second , switch between phone and blue tooth headset , "Di" tone prompt every time .
PAGE 3
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver.