Use and Care Manual

IMPORTANT INSTRUCTIONS
READ & SAVE
IMPORTANT INSTRUCTIONS
1. Disconnect power supply before connections are made to prevent possible electric shock
and/or damage to equipment.
2. Read and follow instructions carefully. Failure to comply with instructions could result in
fire, electric shock, injury to persons, and/or damage to equipment.
3. To reduce the risk of overheating and possible damage to other equipment, this speed
controller is only intended for use with the iLIVING Variable Speed Shutter Exhaust Fans
(ILG8SF7V , ILG8SF10V, ILG8SF12V, ILG8SF16V, ILG8SF18V, ILG8SF20V, and
ILG8SF24V). Do not install this remote control kit on any other fan or appliance.
4. All wiring should conform to the United States National Electrical Code and all applicable
local/state regulations.
5. Do not mount the control kit in an area which will likely expose the control kit to moisture.
6. Make certain the entire installation is grounded as a precaution against possible electrical
shock.
7. Do not exceed maximum amperage rating of the control kit as overloading can result in
damage to the shutter exhaust fan and control kit.
8. When wiring an electrical appliance or device follow all electrical and safety codes, as
well as the most recent United States National Electrical Code (NEC) and the
Occupational Safety and Health Act (OSHA).
9. Install control kit in a well-ventilated area.
CAUTION: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE
THIS CONTROL KIT IN AN INSULALTED WALL