User Manual

Product Overview

How to Use

Charging

1. The end of the Micro USB charging cable into the charging port and the other end plugs into a

standard USB power outlet, such as a laptop or desktop computer.

2. When charging, the LED light flashes once for 1s, and the LED light is on when the charging is

completed.

3. For the first time will take three hours to complete the charge, after each charge takes only half

an hour.

Pairing

Pair in TX mode

1) Put 3.5mm audio cable into the audio hole, the other end (or 2 * RCA) audio source connected

to the system output holes. (Such as iPod, TV, MP3, etc.)

2) Make sure the mode switch to TX mode toggle

3) the product and Bluetooth receiver (usually a Bluetooth headset) in the range of 10 m

4) The Bluetooth receiver is turned on and set to pairing mode.

5) LED flash, which means that it is in pairing mode

6) The device will automatically search for a Bluetooth receiver, and pairing and connection

7) After a successful connection, the LED light will flash once for 5 seconds

8) Pairing is complete, and now you can enjoy wireless audio

Pair in RX mode

1) Put the 3.5mm audio cable into the audio holes, and the other of cable into the home stereo

system definition (ordinary sound).

2) The product and on the phone with a Bluetooth-enabled within 10 meters range

3) Set the phone to Bluetooth mode. In iPhone Case Study: In your Homepage, click on "Settings"

→ "General Settings" → "Bluetooth" → "Open."

Note: Different mobile phones and tablet turn on Bluetooth, paired, connected Bluetooth device

does not like

PAGE 1
Product Overview How to Use Charging 1. The end of the Micro USB charging cable into the charging port and the other end plugs into a standard USB power outlet, such as a laptop or desktop computer. 2. When charging, the LED light flashes once for 1s, and the LED light is on when the charging is completed. 3. For the first time will take three hours to complete the charge, after each charge takes only half an hour. Pairing Pair in TX mode 1) Put 3.
PAGE 2
4) iPhone will automatically search for Bluetooth devices, click "B3601" in the list, and click "Yes" or "OK" accordingly. 5) After successful pairing, the LED light flashes once for 5 seconds. In TX mode Pairing with two devices at the same time 1.Follow the previous instructions in the “Pairing” section to pair the B3601 with your first device. 2.