GMSSL-G060 Draft User Manual 2022/03/25
Remote Layout Six Function Buttons: 1 2 3 4 5 6 1. 2. 3. 4. 5. 6.
Programming Instructions 1. 2. 3. 4. Press and Hold Lock & Panic until LED blinks Release buttons Enter code with buttons 1, 6 & 2 (Lock, Panic & Unlock) a. Example: Code 213, press Lock twice, then Panic once, then Unlock three times b.
Operation Make sure you are within range of the vehicle before using the remote. ● ● ● ● ● ● Press Lock to lock all doors. Press Unlock to unlock the driver’s door. ○ Press Unlock again within 5 seconds to unlock all doors. Double tap the Trunk button to open the trunk. Press and Hold the Panic button for longer than 0.5 seconds to sound the vehicle’s Panic Alarm. ○ Press any button to stop the Panic Alarm Press the Roof button to open/close the roof.
Battery Replacement If the battery needs to be replaced: 1. 2. 3. 4. Push the button on the side of the remote to remove the emergency key. Use the emergency key to pry the two halves of the remote apart at the space next to where the key was removed from. Replace the battery with a CR2032 cell with the “+” side facing down into the plastic. Press the two shell halves back together and replace the emergency key.
FCC Regulatory Statement Model: GMSSL-G060 FCC ID: X32-GMSSG060 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
IC Regulatory Statement Model: GMSSL-G060 IC: 8797A-GMSSG060 CAN ICES-3 (B)/NMB-3(B) This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: ● This device may not cause interference. ● This device must accept any interference, including interference that may cause undesired operation of the device.
