User Manual

ManualsBrandsiKeyless ManualsElectronicsKeyless Remote

Table Of Contents

2320 Presidential Drive, Suite 101, Durham, NC 27703 USA Voice: 919-381-4235

Certification Exhibit

FCC ID: X32-ARX11B2

IC: 8797A-ARX11B2

FCC Rule Part: 15.231

IC Radio Standards Specification: RSS-210

ACS Project Number: 16-3048

Manufacturer: iKeyless, LLC

Model: 300-0388

Manual

Summary of content (8 pages)

PAGE 1
Certification Exhibit FCC ID: X32-ARX11B2 IC: 8797A-ARX11B2 FCC Rule Part: 15.
PAGE 2
300-0388 Draft User Manual 2016-06-03
PAGE 3
Remote Layout Seven Function Buttons: 1. Panic 2. Door Unlock 3. Door Lock 4. Trunk/Hatch Unlock 5. Remote Start 6. Driver Door Open 7.
PAGE 4
Using the remote Make sure you’re within range of the vehicle before attempting to use the remote. ● ● ● ● ● ● ● To activate the vehicle panic alarm, press and release the panic button. To deactivate the vehicle panic alarm, press any button on the remote. To use the unlock feature, press and release the unlock button. To use the remote lock feature, press and release the lock button. To use the trunk unlock/hatch release feature press the trunk/hatch unlock button.
PAGE 5
Changing the CR2032 battery 1. Remove the valet key by sliding the latch on the top of the Fob sideways with your thumb and pulling on the key with your finger. 2. Insert the tip of the valet key into the key slot and pry apart the two halves of the shell of the Fob. 3. Replace the CR2032 battery making sure to put the + side of the battery towards the back half of the Fob shell. 4. Press the two shell halves back together and replace the valet key.
PAGE 6
FCC/IC Label The FCC/IC label is located on the back cover of the remote.
PAGE 7
FCC Regulatory Statement Model: 300-0388 FCC ID: X32-ARX11B2 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 8
IC Regulatory Statement Model: 300-0388 IC: 8797A-ARX11B2 Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.