RENLIG FWMND6 GB
ENGLISH 4
ENGLISH 4 Contents Safety information Product description Control panel First use Personalisation Daily use Helpful hints and tips Washing programmes 4 7 8 10 11 11 14 15 Consumption values Care and cleaning What to do if… Technical data Installation Electrical connection Environment concerns IKEA GUARANTEE 18 19 22 25 26 26 27 27 Subject to change without notice Safety information For your safety and correct operation of the appliance, read this manual carefully before installation and use.
ENGLISH Installation • A qualified and competent person must do the electrical and the plumbing installation. • This appliance is heavy. Take care when you move it. • Make sure that the appliance is not damaged because of transport. Do not connect a damaged appliance. If necessary, contact dedicated After Sales Service. • Remove all packaging and transit bolts before first use. Serious damage can occur to the appliance or to neighbouring cabinets or furniture.
ENGLISH • Never use the appliance if the power supply cable, the control panel, the working surface or the base is damaged so that the inside of the appliance is accessible. Water inlet • This appliance must be connected to a cold water supply. • Do not use connection hoses from an old appliance to connect it to the water supply. • The water pressure must be in the limits (refer to the chapter «Technical data» table).
ENGLISH 7 Product description 1 1 2 3 4 5 6 2 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash. If using liquid detergent pour it just before starting the programme.
ENGLISH 8 Control panel Below is a picture of the control panel. It shows the programme selector dial as well as the buttons and the indicator lights. These are presented by relevant numbers on the following pages.
ENGLISH 9 Programme selector dial It allows you to switch the appliance On/Off and/or to select a programme. Spin reduction button By pressing this button you can change the spin speed of the selected programme. • No Spin option: by selecting this option, all spinning phases are suppressed and replaced by a drain, so as not to wrinkle the laundry. Recommended for extremely delicate fabrics.
ENGLISH 10 Door Locked indicator light The indicator light 3 illuminates when the programme starts and indicates if the door can be opened: • light on: the door cannot be opened. The machine is working or has stopped with water left in the tub. • light off: the door can be opened. The programme is finished or the water has been emptied out. • light blinking: the door is opening in a few minutes.
ENGLISH 3. 11 Pour 1/2 a measure of detergent into the main wash compartment and start the appliance. Pour 2 liters of water into the main of the detergent wash compartment drawer in order to activate the ECO valve. Select a cotton cycle at the highest temperature without any laundry in the appliance, to remove any manufacturing residue from the drum and tub.
ENGLISH 12 details in "Degrees of water hardness". 2 Pour fabric softener into the compartment marked (must not exceed the «MAX» mark in the drawer). Close the drawer gently Select the required programme by turning the programme selector dial (1) The appliance is now switched on. The indicator light of button 5 starts to blink. At the end of the programme the selector dial must be turned to position O, to switch the appliance off.
ENGLISH 3. 13 Press button 5 again to start the programme. Press the button again to restart the programme. • The selected delay can be changed only after selecting the washing programme again. • The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to PAUSE by pressing button 5 and wait a few minutes before opening the door. After you have closed the door, press the same button again.
ENGLISH 14 Stand by : once the programme has finished after a few minutes the energy saving system will be enabled. The brightness of the display is reduced. By pressing any button the appliance will come out of the energy saving status. At the end of the programme, the door is released and can be opened. Turn the programme selector dial to to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty.
ENGLISH 15 Degrees of water hardness Characteristic German °dH French °T.H. Hard 15-21 26-37 Very hard > 21 > 37 A water softener must be added when water has a medium-high degree of hardness. Follow the manufacturer’s instructions. The quantity of detergent can then always be adjusted (reduced) to degree of hardness soft. Washing programmes Coloured cotton (normally-lightly soiled items).
Main wash Rinses Max. final spin at 900 rpm DELICATES 40°-30°-Cold Delicate fabrics: for example curtains. Main wash Rinses Max. final spin at 700 rpm HANDWASH 30°-Cold Special programme for delicate fabrics with «hand washing» care symbol. Main wash Rinses Max. final spin at 900 rpm WOOL 40° Special programme for wool garments bearing the «Pure new wool, nonshrink, appliance washable» label. Main wash Rinses Max.
DRAIN Prewash Soak for about 40 minutes Stop with water in the tub 6 kg With this programme it is possible to rinse and spin cotton garments which have been washed by hand. The appliance performs some rinses, followed by a final long spin. The spin speed can be reduced. Rinses Max. final spin at 1200 rpm For emptying out the water of the last rinse in programmes with the Rinse Hold option selected. Draining of water 6 kg 6 kg Detergent Compartment Special programme for heavily soiled laundry.
Max. final Separate spin for spin at hand washed garments and after pro- 1200 rpm grammes with the Rinse Hold option selected. You can choose the spin speed by pressing the relevant button to adapt it to the fabrics to be spun. SPIN Detergent Compartment Available Options Type of laundry Cycle Description Max. Load Red. Load1) 18 Programme/ Temperature ENGLISH Spin 6 kg 1) If you select the SUPER QUICK option, we recommend you, to reduce the maximum load as indicated. (Red. load = reduced load).
ENGLISH 19 Care and cleaning Warning! Switch the appliance off before you carry out any cleaning or maintenance work. Maintenance Wash With the use of low temperature washes it is possible to get a build up of residues inside the drum. We recommend that a maintenance wash be performed on a regular basis. To run a maintenance wash: • The drum should be empty of laundry. • Select the hottest cotton wash programme. • Use a normal measure of detergent, must be a powder with biological properties.
ENGLISH 1 20 4 1 Open the pump door. Put a container below the recess of the drain pump to collect the water that flows out. 2 Pull back the drainage duct. Unscrew the filter and remove it. 5 2 Remove fluff and objects from the pump. Press the two levers and pull forward the drainage duct to let the water flow out. 6 3 When the container is full of water, put the drainage duct back again and empty the container. Do steps 3 and 4 again and again until no more water flows out from the drain pump.
ENGLISH 21 Clean the filter under the water tap and put it back in the pump into the special guides. Make sure that you tighten correctly the filter to prevent leakages. • Unscrew the hose from the appliance. Keep a rag nearby because some water may flow. • Clean the filter in the valve with a stiff brush or with the piece of cloth. 8 3 35° Close the pump door.
ENGLISH 4. 5. 6. 7. 22 open the pump door; place a container on the floor below the recess of the drain pump; press the two levers and pull forward the drainage duct to let the water flow out; when the container is full of water, put the drainage duct back again and empty the container; repeat this operation until water stops flowing out; 8. if necessary clean the pump (refer to the section ‘Cleaning the pump’ ); 9. close the drain pump door.
ENGLISH Problem 23 Possible cause Solution Select the draining or spinning An option or a programme that programme. ends with the water still in the tub or a that eliminates all the spinning phases has been selected. Close the door firmly. The appliance door is open or not closed correctly. The appliance does not start: The appliance spinning phase starts late or does not start: The plug is not properly inserted in the power socket. Insert the plug into the power socket.
ENGLISH Problem The door will not open: The appliance produces an unusual noise 24 Possible cause Solution The drain or inlet hose is damaged. Replace it with a new one (check with the After Sales Service the right spare part number). The filter has not been properly screwed in after cleaning action. Screw the filter fully in. The washing programme is still running. Wait the end of washing programme. The door lock has not been released.
ENGLISH 25 Model description (MOD): ..................... Product number (PNC): ........................... Serial number (S.N.): ............................... Made In Italy © Inter IKEA Systems B.V. 1999 000.000.00 21552 Technical data Dimensions Water supply pressure1) Width (cm) 59.6 Height (cm) 84.5 Depth (cm) 48.4 max. Minimum Maximum Cotton max. load (kg) 6 Max.
ENGLISH 26 Installation Caution! Refer to the assembly instructions, in order to proceed with the installation. Warning! Make sure that mains plug is disconnected from the mains socket during installation. If a repair is necessary, the appliance must be easily accessible for the engineer. Put the appliance adjacent to a water tap and a drain. Water inlet 1 Connect the hose to a tap with 3/4" thread. 2 Turn the inlet hose to the left or the right to suit the installation.
ENGLISH Warning! The appliance is supplied with a 13 amp plug attached. Use a 13 amp ASTA approved (BS 1362) fuse if it is necessary to change the fuse in the plug 27 supplied. A cut off plug inserted into a 13 amp socket is a serious safety danger. Make sure that it is disposed of safely. Environment concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste.
ENGLISH What will IKEA do to correct the problem? IKEA appointed service provider will examine the product and decide, at its sole discretion, if it is covered under this guarantee. If considered covered, IKEA service provider or its authorized service partner through its own service operations, will then, at its sole discretion, either repair the defective product or replace it with the same or a comparable product. What is not covered under this guarantee? • Normal wear and tear.
ENGLISH 1. make a service request under this guarantee; 2. ask for clarification on installation of the IKEA appliance in the dedicated IKEA kitchen furniture. The service won’t provide clarifications related to: – the overall IKEA kitchen installation; – connections to electricity (if machine comes without plug and cable), to water and to gas since they have to be executed by an authorized service engineer. 3. ask for clarification on user manual contents and specifications of the IKEA appliance.
Country België Belgique Phone number 070 246016 Call Fee Opening time Binnenlandse gesprekskosten 8 tot 20 Weekdagen Tarif des appels nationaux 8 à 20. En semaine България 0700 10 218 Такса за повикване от страната От 9 до 18 ч в работни дни Česká republika 246 019721 Cena za místní hovor 8 až 20 v pracovních dnech Danmark 70 15 09 09 Landstakst man.-fre. 09.00-20.00 lør. 09.00-16.00 1 søndag pr. måned, normalt første søndag i måneden 01803-334532 (0,09 € / Min.
132939331-A-122011 © Inter IKEA Systems B.V.
