RENLIG FWM7 GB
ENGLISH 4
ENGLISH 4 Contents Safety information Product description Control panel First use Personalisation Daily use Helpful hints and tips Washing programmes 4 7 8 10 11 11 14 15 Consumption values Care and cleaning What to do if… Technical data Installation Electrical connection Environment concerns IKEA GUARANTEE 17 18 21 24 25 25 26 26 Subject to change without notice Safety information For your safety and correct operation of the appliance, read this manual carefully before installation and use.
ENGLISH Installation • A qualified and competent person must do the electrical and the plumbing installation. • This appliance is heavy. Take care when you move it. • Make sure that the appliance is not damaged because of transport. Do not connect a damaged appliance. If necessary, contact dedicated After Sales Service. • Remove all packaging and transit bolts before first use. Serious damage can occur to the appliance or to neighbouring cabinets or furniture.
ENGLISH • Never use the appliance if the power supply cable, the control panel, the working surface or the base is damaged so that the inside of the appliance is accessible. Water inlet • This appliance must be connected to a cold water supply. • Do not use connection hoses from an old appliance to connect it to the water supply. • The water pressure must be in the limits (refer to the chapter «Technical data» table).
ENGLISH 7 Product description 1 1 2 3 4 5 6 2 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash. If using liquid detergent pour it just before starting the programme.
ENGLISH 8 Control panel Below is a picture of the control panel. It shows the programme selector dial as well as the buttons and the indicator lights. These are presented by relevant numbers on the following pages.
ENGLISH 9 Programme selector dial It allows you to switch the appliance On/Off and/or to select a programme. Spin reduction button By pressing this button you can change the spin speed of the selected programme. • No Spin option: by selecting this option, all spinning phases are suppressed and replaced by a drain, so as not to wrinkle the laundry. Recommended for extremely delicate fabrics.
ENGLISH 10 Door Locked indicator light The indicator light 3 illuminates when the programme starts and indicates if the door can be opened: • light on: the door cannot be opened. The machine is working or has stopped with water left in the tub. • light off: the door can be opened. The programme is finished or the water has been emptied out. • light blinking: the door is opening in a few minutes.
ENGLISH 11 • Before the first wash, run a cotton cycle at the highest temperature without any laundry in the machine, to remove any manufacturing resi- due from the drum and tub. Pour 1/2 a measure of detergent into the main wash compartment and start the machine. Personalisation Acoustic signals The machine is provided with an acoustic device, which sounds in the following cases: • at the end of the cycle • if there is a fault.
ENGLISH 2 12 Pour fabric softener into the compartment marked (must not exceed the «MAX» mark in the drawer). When these buttons are pressed, the corresponding indicator lights illuminate. When they are pressed again, the indicator lights go out. If an incorrect option is selected, the integrated red indicator light of the button 5 flashes for 3 times and the message Err appears on the display. For the compatibility among the washing programmes and the options see chapter «Washing Programmes».
ENGLISH • The selected delay can be changed only after selecting the washing programme again. • The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to PAUSE by pressing button 5 and wait a few minutes before opening the door. After you have closed the door, press the same button again. • The Delay Start cannot be selected with the draining programme.
ENGLISH 14 Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Stand by : once the programme has finished after a few minutes the energy saving system will be enabled. The brightness of the display is reduced. By pressing any button the appliance will come out of the energy saving status.
ENGLISH 15 A water softener must be added when water has a medium-high degree of hardness. Follow the manufacturer’s instructions. The quantity of detergent can then always be adjusted (reduced) to degree of hardness soft. Washing programmes SYNTHETICS 60°-40°-30°Cold Coloured cotton (normally-lightly soiled items). Synthetic or mixed fabrics: underwear, coloured garments, non-shrink shirts, blouses. Main wash Rinses Max. final spin at 900 rpm 7 kg 3.
Delicate fabrics: for example curtains. Main wash Rinses Max. final spin at 700 rpm HANDWASH 30°-Cold Special programme for delicate fabrics with «hand washing» care symbol. Main wash Rinses Max. final spin at 900 rpm WOOL 40° Special programme for wool garments bearing the «Pure new wool, nonshrink, appliance washable» label. Main wash Rinses Max.
DRAIN SPIN With this programme it is possible to rinse and spin cotton garments which have been washed by hand. The appliance performs some rinses, followed by a final long spin. The spin speed can be reduced. Rinses Max. final spin at 1600 rpm For emptying out the water of the last rinse in programmes with the Rinse Hold option selected. Draining of water 7 kg Detergent Compartment Available Options Cycle Description Type of laundry RINSES Max. Load Red.
ENGLISH 18 Energy consumption (KWh)2) Water consumption (litre)2) Cottons 40 °C 0.75 58 Synthetics 40 °C 0.5 51 Delicates 40 °C 0.55 63 Wool/ Handwash 30 °C 0.25 58 Programme1) 1) Refer to the display for the programme time. 2) The consumption information shown in this chart is indicative. It can vary depending on the quantity and the type of laundry, on the temperature of the water supply and on the ambient temperature.
ENGLISH 3 19 Use a stiff brush to clean and remove all washing powder residue. Open the pump door. Put a container below the recess of the drain pump to collect the water that flows out. 2 4 5 Cleaning the pump Proceed as follows: Flush out all the removed parts of the dispenser drawer under a tap to remove any traces of accumulated powder. Use the previous brush to clean the recess, ensuring that upper and lower part of it is well cleaned.
ENGLISH 20 5 8 Remove fluff and objects from the pump. Close the pump door. 6 Cleaning the water inlet filters If the appliance takes long to fill with water or doesn't fill, the starting button indicator light blinks in red. Check if the water inlet filters are blocked (see chapter "What to do if..." for more details). Proceed as follows: 1 Make sure that the impeller of the pump can turn. If this does not occur, contact the service centre. 7 1 2 • Turn off the water tap.
ENGLISH 21 3 35° 45° • Screw the hose back to the appliance turning it to the left or the right to suit the installation. Tight the locknut correctly to prevent water leaks. • Turn on the water tap. Frost precautions If the machine is installed in a place where the temperature could drop below 0° C, remove the remaining water from the inlet hose and the drain pump. 1. disconnect the mains plug from the mains socket. 2. close the water tap 3. unscrew the water inlet hose from the tap; 4.
ENGLISH Problem The appliance does not fill: The appliance does not drain the water: 22 Possible cause Solution The water tap is closed. Open the water tap. The inlet hose is squashed or kinked. Check the inlet hose connection. The filter in the inlet hose or the inlet valve filter are blocked. Clean the water inlet filters. (See "Cleaning the water inlet filters" for more details). The water tap is blocked or is furred with limescale. Clean the water tap.
ENGLISH 23 Problem Possible cause The appliance spinning phase starts late or does not start: The electronic unbalance detection Redistribute the load manually or device has cut in because the laun- load more laundry and select the dry is not evenly distributed in the spin programme. drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume.
ENGLISH 24 Problem Possible cause Solution The correct temperature was not selected. Check if you have selected the correct temperature. Excessive laundry load. Reduce the laundry load in according to the "Washing Programmes table". After the check, switch on the appliance and press the button 5 to restart the programme. If the malfunction shows again, contact your After Sales Service. The necessary data for the service centre is on the rating plate.
ENGLISH 25 Average annual water consumption (litres)2) 9000 1) If the pressure in your area is lower or higher, please contact your After Sales Service. 2) The data is based on the washing programme for test institutes assuming 200 cycles per a year. Information on the electrical connection, voltage and overall power is given on the rating plate, on the inner edge of the appliance door. Installation Caution! Refer to the assembly instructions, in order to proceed with the installation.
ENGLISH • Make sure that the electrical information on the rating plate agree with your domestic power supply. • Always use a correctly installed shockproof socket. • Do not use multi-way plugs, connectors and extension cables. There is a risk of fire. • Do not replace or modify the mains cable yourself. Contact the After Sales Service. • Make sure that the mains plug and cable is not squashed or damaged by the back of the appliance. • Make sure that the mains plug is accessible after installation.
ENGLISH What does this guarantee cover? The guarantee covers faults of the appliance, which have been caused by faulty construction or material faults from the date of purchase from IKEA. This guarantee applies to domestic use only. The exceptions are specified under the headline “What is not covered under this guarantee?” Within the guarantee period, the costs to remedy the fault e.g.
ENGLISH How country law applies The IKEA guarantee gives You specific legal rights, which covers or exceed local demands. However these conditions do not limit in any way consumer rights described in the local legislation Area of validity For appliances which are purchased in one EU country and taken to another EU country, the services will be provided in the framework of the guarantee conditions normal in the new country.
Country België Belgique Phone number 070 246016 Call Fee Opening time Binnenlandse gesprekskosten 8 tot 20 Weekdagen Tarif des appels nationaux 8 à 20. En semaine България 0700 10 218 Такса за повикване от страната От 9 до 18 ч в работни дни Česká republika 246 019721 Cena za místní hovor 8 až 20 v pracovních dnech Danmark 70 15 09 09 Landstakst man.-fre. 09.00-20.00 lør. 09.00-16.00 1 søndag pr. måned, normalt første søndag i måneden 01803-334532 (0,09 € / Min.
132939152-A-192011 © Inter IKEA Systems B.V.