RENLIG FWM7 GB
ENGLISH 4
ENGLISH 4 Contents Safety information Product description Control panel First use Personalisation Daily use Helpful hints and tips Washing programmes 4 7 8 10 11 11 14 15 Consumption values Care and cleaning What to do if… Technical data Installation Electrical connection Environment concerns IKEA GUARANTEE 17 18 20 23 24 24 25 25 Subject to change without notice Safety information For your safety and correct operation of the appliance, read this manual carefully before installation and use.
ENGLISH Installation • A qualified and competent person must do the electrical and the plumbing installation. • This appliance is heavy. Take care when you move it. • Make sure that the appliance is not damaged because of transport. Do not connect a damaged appliance. If necessary, contact dedicated After Sales Service. • Remove all packaging and transit bolts before first use. Serious damage can occur to the appliance or to neighbouring cabinets or furniture.
ENGLISH • Do not use connection hoses from an old appliance to connect it to the water supply. • The water pressure must be in the limits (refer to the chapter «Technical data» table). Make sure that the local water authority gives you the average mains pressure in your area. • Make sure that there are no kinks in the water inlet hose and that the water inlet hose is not squashed or entangled.
ENGLISH 7 Product description 1 1 2 3 4 5 6 2 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash. If using liquid detergent pour it just before starting the programme.
ENGLISH 8 Control panel Below is a picture of the control panel. It shows the programme selector dial as well as the buttons and the indicator lights. These are presented by relevant numbers on the following pages.
ENGLISH 9 Programme selector dial It allows you to switch the appliance On/Off and/or to select a programme. Spin reduction button By pressing this button you can change the spin speed of the selected programme. • No Spin option: by selecting this option, all spinning phases are suppressed and replaced by a drain, so as not to wrinkle the laundry. Recommended for extremely delicate fabrics.
ENGLISH 10 Delay Start button The programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 20 hours by means of this button. Display The display shows the following information: • 10.1 – Child safety lock. This device permits you to leave the appliance unattended during it's functioning. • 10.2 – Duration of the selected programme. After selecting a programme, the duration is displayed in hours and minutes (for example ).
ENGLISH 11 Personalisation Acoustic signals The machine is provided with an acoustic device, which sounds in the following cases: • at the end of the cycle • if there is a fault. By pressing the 7 and 8 buttons simultaneously for about 6 seconds, the acoustic signal is deactivated (except if there is a fault). By pressing these 2 buttons again, the acoustic signal is reactivated.
ENGLISH 2 12 Pour fabric softener into the compartment marked (must not exceed the «MAX» mark in the drawer). When these buttons are pressed, the corresponding indicator lights illuminate. When they are pressed again, the indicator lights go out. If an incorrect option is selected, the integrated red indicator light of the button 5 flashes for 3 times and the message Err appears on the display. For the compatibility among the washing programmes and the options see chapter «Washing Programmes».
ENGLISH • The selected delay can be changed only after selecting the washing programme again. • The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to PAUSE by pressing button 5 and wait a few minutes before opening the door. After you have closed the door, press the same button again. • The Delay Start cannot be selected with the draining programme.
ENGLISH 14 Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Stand by : once the programme has finished after a few minutes the energy saving system will be enabled. The brightness of the display is reduced. By pressing any button the appliance will come out of the energy saving status.
ENGLISH 15 Washing programmes Main wash Rinses Max. final spin at 1600 rpm Coloured cotton (normally-lightly soiled items). Main wash Rinses Max. final spin at 1600 rpm SYNTHETICS 60°-40°-30°Cold Synthetic or mixed fabrics: underwear, coloured garments, non-shrink shirts, blouses. Main wash Rinses Max. final spin at 900 rpm DELICATES 40°-30°-Cold Delicate fabrics: for example curtains. Main wash Rinses Max.
WOOL 40° JEANS 40° SOAK5) 30° RINSES DRAIN Special programme for wool garments bearing the «Pure new wool, non-shrink, appliance washable» label. Main wash Rinses Max. final spin at 900 rpm With this programme it is possible to wash items like pants, shirts or jackets in denim and also jersey realized with hi-tech materials. Main wash Rinses Max. final spin at 900 rpm Special programme for heavily soiled laundry. The appliance performs a soak at 30° C.
SPIN Separate spin for Max. final hand washed garspin at 1600 ments and after pro- rpm grammes with the Rinse Hold option selected. You can choose the spin speed by pressing the relevant button to adapt it to the fabrics to be spun. Detergent Compartment Available Options Type of laundry Cycle Description Max. Load Red. Load1) 17 Programme/ Temperature ENGLISH Spin 7 kg 1) If you select the SUPER QUICK option, we recommend you, to reduce the maximum load as indicated. (Red. load = reduced load).
ENGLISH 18 Care and cleaning Warning! Switch the appliance off before you carry out any cleaning or maintenance work. Maintenance Wash With the use of low temperature washes it is possible to get a build up of residues inside the drum. We recommend that a maintenance wash be performed on a regular basis. To run a maintenance wash: • The drum should be empty of laundry. • Select the hottest cotton wash programme. • Use a normal measure of detergent, must be a powder with biological properties.
ENGLISH 19 2 Place a container close to the pump, to collect any spillage. 6 3 Pull out the emergency emptying hose, place it in the container and remove its cover cap. Use a pencil to check whether the pump wheel right at the back of the pump housing can turn. (It is normal for the pumping wheel to turn jerkily.) If the pumping wheel cannot be turned, please contact the After Sales Service. 4 2 1 5 When no more water comes out, unscrew the pump cover and remove it.
ENGLISH 20 1 • Turn off the water tap. • Unscrew the hose from the tap. • Clean the filter in the hose with a stiff brush. • Screw firmly the inlet hose back onto the tap. 2 • Unscrew the hose from the appliance. Keep a rag nearby because some water may flow. • Clean the filter in the valve with a stiff brush or with the piece of cloth. 3 35° 45° • Screw the hose back to the appliance turning it to the left or the right to suit the installation. Tight the locknut correctly to prevent water leaks.
ENGLISH 21 Warning! Switch off the appliance before you do the checks. Problem The appliance does not fill: The appliance does not drain the water: Possible cause The water tap is closed. Open the water tap. The inlet hose is squashed or kinked. Check the inlet hose connection. The filter in the inlet hose or the inlet Clean the water inlet filters. (See valve filter are blocked. "Cleaning the water inlet filters" for more details). The water tap is blocked or is furred Clean the water tap.
ENGLISH 22 Problem Possible cause The appliance spinning phase starts late or does not start: The electronic unbalance detection Redistribute the load manually or device has cut in because the laun- load more laundry and select the dry is not evenly distributed in the spin programme. drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume.
ENGLISH 23 Problem Possible cause Solution The correct temperature was not selected. Check if you have selected the correct temperature. Excessive laundry load. Reduce the laundry load in according to the "Washing Programmes table". After the check, switch on the appliance and press the button 5 to restart the programme. If the malfunction shows again, contact your After Sales Service. The necessary data for the service centre is on the rating plate.
ENGLISH 24 Average annual water consumption (litres)2) 9000 1) If the pressure in your area is lower or higher, please contact your After Sales Service. 2) The data is based on the washing programme for test institutes assuming 200 cycles per a year. Information on the electrical connection, voltage and overall power is given on the rating plate, on the inner edge of the appliance door. Installation Caution! Refer to the assembly instructions, in order to proceed with the installation.
ENGLISH • Always use a correctly installed shockproof socket. • Do not use multi-way plugs, connectors and extension cables. There is a risk of fire. • Do not replace or modify the mains cable yourself. Contact the After Sales Service. • Make sure that the mains plug and cable is not squashed or damaged by the back of the appliance. • Make sure that the mains plug is accessible after installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.
ENGLISH What does this guarantee cover? The guarantee covers faults of the appliance, which have been caused by faulty construction or material faults from the date of purchase from IKEA. This guarantee applies to domestic use only. The exceptions are specified under the headline “What is not covered under this guarantee?” Within the guarantee period, the costs to remedy the fault e.g.
ENGLISH Area of validity For appliances which are purchased in one EU country and taken to another EU country, the services will be provided in the framework of the guarantee conditions normal in the new country.
Country België Belgique Phone number 070 246016 Call Fee Opening time Binnenlandse gesprekskosten 8 tot 20 Weekdagen Tarif des appels nationaux 8 à 20. En semaine България 0700 10 218 Такса за повикване от страната От 9 до 18 ч в работни дни Česká republika 246 019721 Cena za místní hovor 8 až 20 v pracovních dnech Danmark 70 15 09 09 Landstakst man.-fre. 09.00-20.00 lør. 09.00-16.00 1 søndag pr. måned, normalt første søndag i måneden 01803-334532 (0,09 € / Min.
132939150-B-012011 © Inter IKEA Systems B.V.
