User Manual

User manual of Remote Control

1、 Model No.: ICTD-KL-1

2、Technical Parameter

a) WORKING VOLTAGE: 1.8~3.6 V(Normal：2X1.5VDC);

b) Transmit speed: 250KHz;

c) Frequency band: 2436.20 +/- 0.03 MHz

3、Application

This Remote Control can match with 10W, 20W and 30W dimmable LED drivers. The match method is following:

a) Punched the code button on Receiver, the indicator lighted, you can undertake to code.

b) In the case of the receiver indicator light, extended press the button on remote control until the indicator second lighted.

Complete send code command.

c) Once receiver received the code command, the indicator flash three times showing the code is successful, after lights

out.

There are three kinds of remote control dimmer.

Press the remote control button, dimming state change by the cycle: OFF->35%->100%->35%->OFF.

4、Remote Control Block Diagram:

5、Driver Block Diagram:

PAGE 1
User manual of Remote Control 1、 Model No.: ICTD-KL-1 2、Technical Parameter a) WORKING VOLTAGE: 1.8~3.6 V(Normal：2X1.5VDC); b) Transmit speed: 250KHz; c) Frequency band: 2436.20 +/- 0.03 MHz 3、Application This Remote Control can match with 10W, 20W and 30W dimmable LED drivers. The match method is following: a) Punched the code button on Receiver, the indicator lighted, you can undertake to code.
PAGE 2
Caution: This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.