Charger for iPhone/iPad with iRig devices USER MANUAL
Contents Table of Contents Contents 2 English 3 iRig PowerBridge 3 Register your iRig PowerBridge 3 Firmware update required 4 Important safety informations 5 Installation and setup 6 iRig accessories with Mini-DIN connector 6 iRig accessories with Micro-USB connector 8 iRig PowerBridge status LED 9 Troubleshooting 9 Specifications 9 Warranty 9 Support and more info 9 2
English iRig PowerBridge Thank you for purchasing iRig PowerBridge, the first universal charging solution for all iPhone, iPad and iPod touch and digital iRig accessories. Your package contains • iRig PowerBridge (Lightning or 30-pin version) • Mini-DIN to Mini-DIN cable • Mini-DIN to Micro-USB cable • Power supply unit • Power adapter cable • Quick start guide • Registration card iRig PowerBridge is a charging system for iPhone, iPad and iPod touch and digital iRig accessories.
English Firmware update required Do not use your iRig PowerBridge until you update the firmware in your IK digital accessory. Visit the address below to download the updater and for more information. www.ikmultimedia.
English Important safety informations This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure - voltage that may be sufficient to constitute a risk of shock. This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. Please read the manual. Caution Current surges or voltage transients on the mains supply, or electrostatic discharges, may cause accessory communication to fail.
English Installation and setup iRig accessories with Mini-DIN connector 1. Connect the AC power adapter to the main electricity grid. 2. Connect the included Mini-DIN to Mini-DIN cable to the iRig accessory.
English 3. Connect the included Mini-DIN cable to the Mini-DIN port on iRig PowerBridge. 4. Connect the Lightning or 30-pin captive cable to your iOS device.
English 5. Now your iOS device is charging. Please note that if you iOS device shows you the “Not Charging” message, then the digital iRig accessory you are using needs a firmware update. Please visit your user area to install the latest update: www.ikmultimedia.com/userarea iRig accessories with Micro-USB connector 1. Connect the AC power-adapter to the main electricity grid. 2. Connect the included Mini-DIN to Micro-USB cable to the Micro-USB port on the iRig accessory. 3.
English iRig PowerBridge status LED The front LED lights up when iRig PowerBridge is connected to the main AC supply and an iRig accessory is connected. Note: This LED does NOT indicates the charge status of the battery. Troubleshooting I have connected iRig PowerBridge to the main AC supply but my iOS device is not charging and the LED is off. Remember to always connect your iRig digital accessory to the iRig PowerBridge’s Mini-DIN port. Only after this will your iOS device be charged.
FCC statement This device complies with Part 15.107 and 15.109 Class B of the FCC Rules CFR47: October 2010. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.