iBN24 Portable Rechargeable NFC Bluetooth Speaker instruction manual
iBN24 FCC ID: EMOIBN24 IC: 986B-IBN24 FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
IC Statement This device complies with Industry Canada RSS-210. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio RSS-210.
iBN24 Introduction Thank you for purchasing the iHome iBN24. This product is designed to provide high quality wireless sound for your iPad, iPhone, iPod, computer, PDA or other Bluetooth audio device. Along with the included Quick Bluetooth Connection Guide this instruction booklet explains the basic operation and care of the unit. Please read them carefully and keep for future reference.
iBN24 Included • iBN24 system • Micro USB to USB charging cable • 3.
iBN24 Meet Your iBN24 NFC Antenna Top Power/Charging/Pairing Indicator Light Front Back Reset port Aux-in Jack Micro USB Charging Port Aux-out Jack Bluetooth Pairing Button Power On/Off Switch 3
Using the Charging the Unit iBN24 1. Connect the micro USB plug to the micro USB charging port on the back of the unit. Charge via computer USB port, USB AC adaptor or other powered USB port iHome BN24 USB port Computer connected to working outlet Computer USB port NOTE: When unit is on and not connected to power source, the red light will slowly flash for a short time (10 times each minute) to indicate the battery needs charging. 2.
Using Bluetooth: Pairing and Playing Your Device Using NFC Using the iBN24 This unit features wireless NFC pairing, which allows playing NFC–enabled devices to pair and play instantly. For pairing non-NFC devices, please see the following section “Pairing Your Device Manually”. 1. Turn on your Bluetooth–enabled/NFC–enabled device and turn on NFC capability (typically under Settings) as described in the device’s user manual. 2. Place your NFC–enabled device in play mode. 3.
Using Bluetooth: Pairing Your Device Manually Using the iBN24 For First Time use (auto pairing): 1. Turn on your Bluetooth-enabled device and turn on Bluetooth capability as described in the device’s user manual. 2. Move the Power ON/OFF Switch on the unit to the ON position (right). The first time the unit is turned on it will enter auto pairing mode, indicated by a rapidly flashing blue light.
Using the Using Bluetooth: Pairing Your Device (cont’d) iBN24 “iHome iBN24” should appear on your device’s menu. If “Not Paired”, “Not Connected” or similar message appears, tap on “iHome iBN24“ to complete pairing. If your device asks for a password, enter 1234 on the keyboard of your device. If no device is paired within 2 minutes, the unit will revert to auto link mode. To retry pairing, press and hold the Bluetooth Pairing Button again. Playing Audio Via Bluetooth 1.
Using the Playing Audio via Aux In iBN24 1. Connect the included 3.5 mm audio cable plug to the headphone or line-out jack on your audio device and the other end into the Aux-in Jack on the back of the unit. 2. Move the Power ON/OFF Switch to the ON position (right) to listen to audio via aux in. The indicator light will flash blue. 3. Power on the audio device and use the controls on the device to play or pause audio, navigate tracks and control volume.
Troubleshooting Unit doesn’t respond (no power) • Make sure unit is completely charged. • Check that all connections are correct and properly plugged in. • Make sure your device is properly paired with the iBN24. • Make sure the Power ON/OFF Switch is not in the OFF (left) position. • If the unit cannot be charged up, please remove the aux-in cable from the unit and slide the Power ON/OFF Switch to OFF postion before charging.
Internal Rechargeable Lithium-ion Battery This device uses an internal rechargeable lithium-ion battery that should last the lifetime of the device. If you suspect your battery may be dead, try charging it several times. If the battery does not recharge, please contact us for repair information. WARNING/DISPOSAL OF UNIT Please do NOT attempt to change the battery yourself.
Consumer Product Safety Guide IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1.
8. Attachments – Do not use attachments not recommended by the product manufacturer. 9. Lightning and Power Surge Protection – Unplug the unit from the wall socket and disconnect the antenna or cable system during a lightning storm or when it is left unattended and unused for long periods of time. This will prevent damage to the product due to lightning and power-line surges. 10.
Limited 1 Year Warranty iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of one (1) year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased.