Operating Instructions

Funkzulassung
Homologation radio
Radio approval
DTI
ð
80302373 / 0003 / 2021
/
Europäische Union / L‘Union Europe / European Union
Deutsch
DTI801
Vor Inbetriebnahme die Bedienungsanleitung lesen und während der
Einsatzdauer aufbewahren.
Hiermit erklärt die ifm electronic GmbH, dass das Gerät der Richtlinie
2014/53/EU entspricht.
Der vollständige Text der EU-Konformitätserklärung, Technische Daten,
Anleitungen, Zulassungen, Kontakte und weitere Informationen unter
documentation.ifm.com.
WARNUNG!Der Betrieb dieses Gerätes kann Funkstörungen in
Wohngebieten verursachen.
Das Gerät hat eine Arbeitsfrequenz von 865 bis 868 MHz und eine
maximale Sendeleistung von 22,5dBm ERP.
Aufgrund der Human-Exposure-Vorschrift einen Mindestabstand
zwischen Gerät und Personen von 20 cm einhalten.
Das Gerät sendet Funkwellen aus, die möglicherweise den Betrieb von
elektronischen Geräten in der Nähe beeinträchtigen, darunter
Herzschrittmacher, Hörelemente und Defibrillatoren. Wenn Sie einen
Herzschrittmacher oder ein anderes implantiertes Medizinprodukt
haben, verwenden Sie das Gerät nicht ohne vorherige Rücksprache mit
Ihrem Arzt oder dem Hersteller Ihres Medizinprodukts. Halten Sie einen
Sicherheitsabstand zwischen dem Gerät und Ihren Medizinprodukten
ein und sehen Sie von der weiteren Verwendung des Gerätes ab, wenn
Sie eine dauerhafte Beeinträchtigung Ihres Medizinprodukts
beobachten.
Français
DTI801
Lire la notice d‘utilisation avant l‘utilisation et conserver-la pendant toute la
durée d‘utilisation.
ifm electronic gmbh déclare par la présente que l‘équipement
correspond à la directive 2014/53/EU.
Vous trouverez le texte intégral de la déclaration de conformité de l‘UE,
les données techniques, les instructions, les homologations, les
contacts et d‘autres informations sur le site documentation.ifm.com.
AVERTISSEMENT!Le fonctionnement de cet appareil peut causer des
interférences radio dans les zones résidentielles.
L'appareil a une fréquence de fonctionnement de 865 à 868 MHz et une
puissance d'émission maximale de 22,5 dBm ERP.
En raison des réglementations relatives à l‘exposition humaine, une
distance minimale de 20 cm doit être maintenue entre l‘appareil et les
personnes.
L‘appareil émet des ondes radio qui peuvent interférer avec le
fonctionnement des appareils électroniques situés à proximité,
notamment les stimulateurs cardiaques, les appareils auditifs et les
défibrillateurs. Si vous avez un stimulateur cardiaque ou un autre
dispositif médical implanté, n‘utilisez pas l‘appareil sans avoir consulté
au préalable votre médecin ou le fabricant de votre dispositif médical.
Maintenez une distance de sécurité entre l‘appareil et vos dispositifs
médicaux et ne continuez pas à utiliser l‘appareil si vous constatez une
déficience permanente de votre dispositif médical.
English
DTI801
Read the operating instructions before set-up and keep them for the
duration of use.
ifm electronic gmbh hereby declares that the device is in compliance
with Directive 2014/53/EU.
The full text of the EU Declaration of Conformity, technical data,
instructions, approvals, contacts and further information at
documentation.ifm.com.
WARNING!The operation of this device can cause radio interference in
residential areas.
The device has an operating frequency of 865 to 868 MHz and a
maximum transmitter power of 22,5 dBm ERP.
Due to radio frequency exposure limits this device should be installed
and operated with a minimum distance of 20 cm between the device
and the body of the user or nearby persons.
The device emits radio waves that may interfere with the operation of
electronic devices in the vicinity, including pacemakers, hearing aids
and defibrillators. If you have a pacemaker or other implanted medical
device, do not use the sensor without first consulting your doctor or the
manufacturer of your medical device. Keep a safe distance between the
device and your medical products and refrain from further use of the
device if you observe permanent impairment of your medical devices.
USA
English
DTI901
FCC information:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following three conditions:
1. This device must not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
3. The distance between the read/write head and an ID tag must be > 20
cm.
Changes or modifications to this device that have not been expressly
approved by ifm could void the user‘s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
expense.
RF Exposure Info:
Due to radio frequency exposure limits this device should be installed and
operated with a minimum distance of 20 cm between the device and the
body of the user or nearby persons.
The measurement results comply with the FCC limit per 47 CFR §2.1091
for the uncontrolled RF Exposure of mobile devices.
Canada / Canada
Français
DTI901
Avis ISDE:

Summary of content (2 pages)