IR E VI SO PR O IER i420 PRINTER USER SAFETY AND START GUIDE N0L8S2A6 P1 October 2, 2019
IR E PR O VI SO IER i420 User Safety and Start Guide 1. I420-220 PRODUCT TESTED AT 230 V, 50HZ, FOR EC MEASUREMENTS This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment may cause radio interference.
IR E PR O VI SO IER i420 User Safety and Start Guide IC This equipment complies with RSS102’s radiation exposure limits set forth for an uncontrolled environment under the following conditions: 1. This equipment should be installed and operated such that a minimum separation distance of 20cm is maintained between the radiator (antenna) and user’s/nearby person’s body at all times. 2. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
IR E PR O VI SO IER i420 User Safety and Start Guide SAFETY INSTRUCTIONS WHICH MUST BE STRICTLY OBSERVED! To prevent personal injury or property damage, the following shall be strictly observed. The degree of possible injury and damage due to incorrect use or improperly following instructions is described below. INDICATES A SITUATION WHICH, IF NOT OBSERVED AND HANDLED PROPERLY, COULD RESULT IN DEATH OR SERIOUS INJURY.
IR E PR O VI SO IER i420 User Safety and Start Guide GENERAL PRECAUTIONS Prior to operation, read the safety instructions carefully and observe them. Do not drop or put foreign matter such as clips and pins into the printer. This may cause problems. Be careful when moving or carrying the printer. Dropping the printer may cause injury or property damage. When moving or carrying the printer, never use the paper support. It is not a handle.
IR E PR O VI SO IER i420 User Safety and Start Guide 1 EQUIPEMENT CHARACTERISTICS DIMENSION AND WEIGHT Width Without stacker With stacker Height Depth Without stacker With stacker Weight 211 mm (8.31 in) 214 mm (8.43 in) 210 mm (8.27 in) 333 mm (13.11 in) 492 mm (19.37 in) 3 kg (6.
IR E PR O VI SO IER i420 User Safety and Start Guide 2 QUICK START GUIDE BEFORE USING THE PRINTER To use the printer: You need a PC with an Internet navigator IERConnect software must be installed on the PC (see IERConnect installation guide). CONNECTING THE PRINTER POWER CORD On the back of the printer, connect the power cord to the printer power socket (1). Connect the power cord to a power grid outlet.
IR E VI SO PR O Siège social / Headquarters - PARIS 3, rue Salomon de Rothschild 92150 SURESNES - FRANCE www.ier.