WIFI-RT5392-SB WIFI-RT5392-SB CPU Card IE I Tec hnology C orp. MODE L : WIF I-R T 5392-S B Wireles s L A N Module with R T 5392 s ingle c hip, 2T 2R , s ingle band, R oHS Us er Manual P age 1 R ev. 1.
WIFI-RT5392-SB R evis ion Date Version Changes 15 December, 2011 1.
WIFI-RT5392-SB C opyright C OP Y R IG HT NOT IC E The information in this document is subject to change without prior notice in order to improve reliability, design and function and does not represent a commitment on the part of the manufacturer. In no event will the manufacturer be liable for direct, indirect, special, incidental, or consequential damages arising out of the use or inability to use the product or documentation, even if advised of the possibility of such damages.
WIFI-RT5392-SB Table of C ontents 1 INTRODUCTION.......................................................................................................... 1 1.1 INTRODUCTION........................................................................................................... 2 1.2 FEATURES ................................................................................................................... 2 1.3 DIMENSIONS ..................................................................................
WIFI-RT5392-SB L is t of F igures Figure 1-1: WIFI-RT5392-SB ..........................................................................................................2 Figure 1-2: WIFI-RT5392-SB Dimensions (mm) ...........................................................................3 Figure 3-1: License Agreement ...................................................................................................10 Figure 1-2: Setup Type ...................................................................
WIFI-RT5392-SB L is t of Tables Table 1-1: WIFI-RT5392-SB Technical Specifications .................................................................4 Table 1-2: WIFI-RT5392-SB Pinouts ..............................................................................................
WIFI-RT5392-SB Chapter 1 1 Introduc tion P age 1
WIFI-RT5392-SB 1.1 Introduc tion Figure 1-1: WIFI-RT5392-SB The WIFI-RT5392-SB is a mini PCI-Express half-size wireless LAN module. It complies with the IEEE 802.11b/g/n standard and supports 2Tx/2Rx 2-stream MIMO to enable data rates up to 300Mbps for a 40MHz channel. The integrated PCIE Wi-Fi RT5392 single chip supports 802.11x authentication, WEP 64/128, WPA, WPA2, TKIP, AES, WAPI encryption and guarantees the wireless network security.
WIFI-RT5392-SB Solid design with external antenna diversity Low power consumption and high performance Supports 802.11x authentication, WEP 64/128, WPA, WPA2, TKIP, AES, WAPI encryption. Supports operating systems-Windows XP, CE6.0, XPE, 2000, Vista 32/64, Windows 7 32/64, Linux, MAC 1.
WIFI-RT5392-SB 1.4 Tec hnic al S pecifications WIFI-RT5392-SB technical specifications are listed in table below. Model W IF I-R T 5392-S B Standards IEEE 802.11b/g/n, Wi-Fi compliant Rate 300 Mbps PHY rate in 2T2R mode Interface PCIe Mini card C ontroller C hip Ralink RT5392 Connectors 2 x U.FL (I-PEX) antenna connectors Security WEP 64/128, WPA, WPA2, TKIP, AES, WAPI Frequency Range 2.4GHz Modulation Type 802.11b (DSSS): CCK, DQPSK, DBPSK 802.11g (OFDM): BPSK, QPSK, 16-QAM, 64-QAM 802.
WIFI-RT5392-SB 1.5 P in Define The pinouts of WIFI-RT5392-SB are listed below: Pin No. definition Pin No. definition 1 NC 2 3.3V 3 BT_DATA 4 GND 5 BT_CHCLK 6 1.5VIN 7 CLKREQ# 8 NC 9 GND 10 NC 11 REFCK_P 12 NC 13 REFCK_M 14 NC 15 GND 16 NC 17 NC 18 GND 19 NC 20 RFTXDIS# 21 GND 22 PERST# 23 PETX0_M 24 NC 25 PETX0_P 26 GND 27 GND 28 1.
WIFI-RT5392-SB Chapter 2 2 Unpac king P age 6
WIFI-RT5392-SB 2.1 Anti-s tatic P recautions WAR NING ! Static electricity can destroy certain electronics. Make sure to follow the ESD precautions to prevent damage to the product, and injury to the user. Electrostatic discharge (ESD) can cause serious damage to electronic components, including the WIFI-RT5392-SB. Dry climates are especially susceptible to ESD.
WIFI-RT5392-SB 2.3 P ac king L is t NOTE: If any of the components listed in the checklist below are missing, do not proceed with the installation. Contact the IEI reseller or vendor the WIFI-RT5392-SB was purchased from or contact an IEI sales representative directly by sending an email to sales@iei.com.tw.
WIFI-RT5392-SB Chapter 3 3 S oftware Drivers P age 9
WIFI-RT5392-SB 3.1 Overview A CD is shipped with the wireless LAN card. The CD contains a user manual and driver for the wireless LAN card. To be able to use the wireless LAN card, please install the driver. Failure to install the driver means that that wireless LAN card cannot be detected by the system. 3.2 Driver Ins tallation To install the wireless LAN driver, please follow the steps below. S tep 1: Insert the CD into a CD drive connected to the system. S tep 2: Double click the Setup.
WIFI-RT5392-SB Figure 1-2: Setup Type S tep 6: Select “Install driver and Ralink WLAN Utility” and click NEXT to continue. S tep 7: The Configuration Tool screen in Figure 1-3 appears. Figure 1-3: Configuration Tool S tep 8: Select “Ralink Configuration Tool”and click NEXT to continue. S tep 9: The Ready to Install the Program screen in Figure 1-4 appears.
WIFI-RT5392-SB Figure 1-4: Ready to Install the Program S tep 10: Click Install to proceed with the installation. S tep 11: The Setup Status screen in Figure 1-5 appears and displays the progress of the installation. Figure 1-5: Setup Status S tep 12: When the driver installation is complete, the screen in Figure 1-6 appears.
WIFI-RT5392-SB Figure 1-6: Installation Complete S tep 13: Click FINISH to complete installation. 3.3 Wireles s C onfiguration After the driver installation is complete, an icon appears at the right down corner of the screen. S tep 1: Double click the icon at the right down corner of the screen to open the configuration tool, as shown in Figure 1-7.
WIFI-RT5392-SB S tep 2: Click the search button to search the available wireless networks, as shown in Figure 1-8. Figure 1-8: Available Networks S tep 3: Double click the wireless network name that with the best signal and the known password to open the Profile Settings screen, as shown in Figure 1-9.
WIFI-RT5392-SB S tep 4: Click to continue, as shown in Figure 1-10. Figure 1-10: WPA Preshared Key S tep 5: Enter the password and click to complete the connection setting.
WIFI-RT5392-SB Appendix A A Hazardous Materials Dis c los ure P age 16
WIFI-RT5392-SB A.1 Hazardous Material Disclosure Table for IPB Products Certified as RoHS Compliant Under 2002/95/EC Without Mercury The details provided in this appendix are to ensure that the product is compliant with the Peoples Republic of China (China) RoHS standards. The table below acknowledges the presences of small quantities of certain materials in the product, and is applicable to China RoHS only.
WIFI-RT5392-SB P art Name T oxic or Hazardous S ubs tanc es and E lements L ead Merc ury C admium Hexavalent P olybrominated P olybrominated (P b) (Hg) (C d) C hromium B iphenyls Diphenyl (C R (V I)) (P B B ) E thers (P B DE ) Hous ing X O O O O X Dis play X O O O O X P rinted C irc uit X O O O O X X O O O O O X O O O O X F an As s embly X O O O O X P ower S upply X O O O O X O O O O O O B oard Metal F as teners C able As s embly As s emb
WIFI-RT5392-SB ppendix B B F C C S tandards P age 19
WIFI-RT5392-SB B .1 Compliance Information FCC Compliance Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This device must accept any interference received, including interference that may cause undesired operation.
WIFI-RT5392-SB NOTE: (1) This device is approved for OEM installation with specified antennas as listed in this Manual. It is the responsibility of the Installer to comply with the separation distance for satisfying RF exposure compliance. (2) This device only could work when being installed into “client devices” which could not transmit automatically, such as Notebook P.C., with the software driver limit.