User Manual RFID Sensor Tags Reader RFID‐ST‐RD‐R10 STRD‐01 iEi Integration Corp. 3F., No22, Zhongxing Rd., Xizhi Dist., New Taipei City 22161, Taiwan http://www.ieimobile.
Description This device is a RFID Sensor Tag reader for serial iEi sensor tags, it was designed for read out instant or near recently sensing data from each RFID sensor tags, which currently support temperature tag (ST‐01, ST‐06, ST‐07), ambient light tag (ST‐02), temperature & humidity tag (ST‐03), GPS tag (ST‐04) and vibration tag (ST‐05). E440 also implement a 107KB USB disk to store scanned tags data like tag ID, current data and maximum and minimum etc.
Specifications Normal Used Range: Storage: Battery: RFID: Charger: IO Port: Water Proof: From ‐20°C to 40°C 107KB USB Disk ( around 500 tags ) 650mAh ISO 15693, 13.56MHz DC‐5V, 1A USB adaptor USB2.
Warranty iEi warrants this product against defects in materials and/or workmanship under normal use for a period of ONE(1) YEAR from the date of purchase by the original purchaser’s Warranty Period. If a valid claim is received within the Warranty Period. iEi will opt to either 1) repair the defect at no charge, or 2) replace the product with a new product that is at least functionally equivalent to the original product. A replacement product or part assumes the remaining warranty of the original product.
DISCLAIM STATUTORY OR IMPLIED WARRANTIES, THEN TO THE EXTENT PERMITTED BY LAW, ALL SUCH WARRANTIES SHALL BE LIMITED IN DURATION TO THE DURATION OF THIS EXPRESS WARRANTY. Warnings Do not store in high temperature, damp condition, and direct sunlight. Do not attempt to disassemble, open, crush, bend or deform. Do not put or dispose of in fire or water. Do not attempt to dry with devices like hair dryer or microwave. Keep out of reach of small children.
A. Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
‐Reorient or relocate the receiving antenna. ‐Increase the separation between the equipment and receiver. ‐Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ‐Consult the dealer or an experienced radio/TV technician for help.
15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference and 2) this device must accept any interference received, including interference that may cause undesired operation of the device.