User's Manual

ManualsBrandsIDT Technology ManualsElectronicsSmartChip



Wireless

SmartClip



forCoaguChek®XS

meter



User

Manual



INTRODUCTION



Thank you for selecting our Wireless SmartClip for your

Roche®

Coagulation Meter, which is a transmission Wireless

SmartClip

accessory that can help you expand the meter from Infrared (IR)

Bluetooth Low Energy (BLE) transmission. This means the

testing

values can be transferred to a counterpart station, such as

2net

Hub or some mobile devices through BLE technology. From now

on,

you can systematically monitor and manage your PT values

via

wireless

technology.



Mobile device with this logo is compatible with the

Wireless

SmartClip to achieve reliable transmission

linkage.



IMPORTANT Please thoroughly read this user manual for all

the

necessary information to operate your Wireless

SmartClip.



OVERVIEW



1. LED

light

2. Battery

compartment

3. ON/OFF

switch

Clip

5. Non-slippery

pads

Summary of content (6 pages)

PAGE 1
INTRODUCTION Wireless SmartClip for CoaguChek® XS meter Thank you for selecting our Wireless SmartClip for your Roche® Coagulation Meter, which is a transmission Wireless SmartClip accessory that can help you expand the meter from Infrared (IR) to Bluetooth Low Energy (BLE) transmission. This means the testing values can be transferred to a counterpart station, such as 2netTM Hub or some mobile devices through BLE technology.
PAGE 2
BATTERY INSTALLATION INSTALLATION Battery is pre-installed in your BLE transmission Wireless SmartClip when you purchase. Please regularly check the battery and replace battery promptly as it may affect the transmission (refer to LED indicator table on page. X). To replace the battery: • Align the coagulation meter with the Wireless SmartClip and insert the meter into the Wireless SmartClip with some pressure until it clips into place. UNINSTALLATION 1.
PAGE 3
• Hold the Wireless SmartClip and pull the meter from the lefthand side with some pressure. • OPERATION After the Wireless SmartClip is installed onto the meter, you need to turn on the Wireless SmartClip to ensure the transmission works. Make sure you power up the coagulation meter in priority of turning on the Wireless SmartClip. The effective distance between a counterpart station, such as a hub, and the coagulation meter should be not far from each other more than 10 meters or 32.
PAGE 4
• • connection • • SPECIFICATIONS Dimension (L x W x H) 84.5 x 131.5 x 36.6 mm (3.3 x 5.2 x 1.5 inches) Power 1 x CR2032 3V lithium battery Weight 52.8 g (1.
PAGE 5
• 70% isopropyl alcohol • 10% Sodium hypochlorite solution (1 part bleach to 9 parts deionized water, made fresh every 24 hours) Do not use any other disinfectants/cleaning solutions on the Wireless SmartClip. and Electronic Equipment). If you have any queries, please refer to the local authorities responsible for waste disposal. Used, fully discharged batteries must be disposed of in a specially labeled collection container, at toxic waste collection points or through an electrical retailer.
PAGE 6
harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.