User Manual

Smart Sleeve
for Roche Accu-Chek Aviva/ Performa
Blood Glucose Meter
User Manual
INTRODUCTION
Thank you for selecting our Smart Sleeve for your Roche
®
Accu-Chek Aviva/ Performa
Blood Glucose Meter, which is a transmission Smart Sleeve accessory that can help you
expand the meter from Infrared (IR) to Bluetooth Low Energy (BLE) transmission. This
means the testing values can be transferred to a counterpart station, such as hub or some
mobile devices through BLE technology. From now on, you can systematically monitor
and manage your blood glucose values via wireless technology.
Mobile device with this logo
is compatible with the Smart Sleeve to achieve
reliable transmission linkage.
IMPORTANT Please thoroughly read this user manual for all the necessary information
to operate your Smart Sleeve.
OVERVIEW
1. LED light
3
1
2
2. Battery compartment
3. Start button
BATTERY INSTALLATION
Battery is pre-installed in your Smart Sleeve when you purchase. Please regularly check
the battery and replace a new battery promptly as it may affect the transmission.
To replace the battery:
1.
Open the battery compartment cover.
2. Remove the old battery and insert a new CR2032, 3V lithium battery. Make sure to
place the battery in the compartment following the polarity +/-.
3. Put on the compartment cover.
INSTALLATION
• Align and then insert the blood glucose
 meterintotheSmartSleeveuntilitts
into place.
UNINSTALLATION
• Hold the Smart Sleeve and pull the meter
out from the top with some pressure.
OPERATION
After the Smart Sleeve is installed onto the meter, you need to turn on the Smart Sleeve
to ensure the transmission works. Make sure you also turn on the blood glucose meter
in its data transferring mode.
NOTE Please refer to the blood glucose meter’s user manual for the data tramission
operation.
NOTE The Start button of the sleeve is placed & designed to be triggered while you
operate the data transmisson mode of blood glucose meter.
NOTE The operation range between a counterpart station, such as a hub, and the
coagulation meter should not be far from each other more than 10 meters or 32.8 feet.
Turn on the Smart Sleeve:
• Turn on the data transmission mode of the blood glucose meter.
• Press and Hold the Start button for two seconds. Red LED indicator turns on.
• The data transmission will start automatically (within 90 seconds), which will be indicated
byaredashingLED.
•Whenitisconnectedtothemobileapplicationthatyoucancollect:1)therstdata,
2) the latest data or 3) all the data.
NOTE The mobile application with the Smart Sleeve can only retrive the data record from
the blood glucose meter. If you need to erase the record that inside the blood glucose
meter, you have to follow its own procedures.
Turn off the Smart Sleeve:
• The Smart Sleeve automatically turns off in 90s.
• After each compete data transmission.
NOTE The operation range between a counterpart station, such as a mobile, and the
Smart Sleeve should be not far from each other more than 10 meters.
LED INDICATOR
Status Lighting
Start & Connecting Flash every 3s
Transmitting data Flash every 0.25s
Low battery Flash every 1s
Total time out 90s