User manual For uTrust TS KEYPAD Version 1.0 Confidential Author Version Date Suresh Kumar T 1.
Document History Version Date 1.
uTrust TS KEYPAD User Manual Contents 1.0 Introduction ................................................................................................................................ 4 2.0 Reader ......................................................................................................................................... 4 2.1 2.2 2.3 Functionality..............................................................................................................................
uTrust TS KEYPAD User Manual 1.0 Introduction This document details the Physical Access Control Reader uTrust TS KEYPAD and its basic user instruction and installation procedures. 2.0 Reader 2.1 Functionality TS KEYPAD reader is a physical access control smart card reader that can read HF and LF contactless credentials, conforming to the following standards: ISO 14443 A & B, ISO15693 with a keypad pin entry for additional security.
uTrust TS KEYPAD User Manual 2.
uTrust TS KEYPAD User Manual 3.0 Product details Model Name : uTrust TS keypad Device Type : RFID reader, 13.
uTrust TS KEYPAD User Manual 6.0 Installation details 6.1 Parts List • • • • • • • 6.2 TS Keypad reader -1 Screws (A #6-18X1.
uTrust TS KEYPAD User Manual Caution: During Wiring make sure that the +VDC lines does not make contact with any other cables, as it might affect reader functionality/ cause damage to the reader.
uTrust TS KEYPAD User Manual 6.4 Mounting the Reader 6.4.1 Location of mounting holes on wall Phoenix connector Reader – 4 Holes and 1 Slot 6.4.2 Reader Installation Steps a. b. c. d. Make holes on the wall as per the image above. Insert the nylon screw plugs into the wall. Connect the wires as per the Table 2 or Table 3. TouchSecure® reader with Bottom Casing is to be now secured onto the wall using the Screws (A #6-18X1.5" SS ) e. The top casing can be inserted onto the bottom casing f.
uTrust TS KEYPAD User Manual Page 10 of 12
uTrust TS KEYPAD User Manual Power up and Testing 7.0 1 Turn power on The LED blinks 3 times green with a long beep, then turns red 2 Present a card The LED blinks green, and a short Beep is emitted 3 Press Key Buzzer tone & backlight LED blinks 4 RJ45 Ethernet cable Reader can be powered from POE. Communication happens through Ethernet also. 5 Wiegand / RS485 Communication to the Panel is done through Wiegand / RS485 / OSDP. This is the default reader behavior.
uTrust TS KEYPAD User Manual 8.0 Certifications 8.1 FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.