SDI010-MOD OEM Integration Manual Version 1.
SDI010-MOD OEM Integration Manual v1.0 SCOPE The scope of this document is to explain the fine points of integrating the SCM SDI010 Rev 0.2 dual interface reader modules into other devices.
SDI010-MOD OEM Integration Manual v1.0 MOUNTING It is recommended that the module is mounted so that the antenna that runs along the periphery of the PCBA is parallel to the card placement position inside the device. The board has two mounting holes located diagonally across. It is recommended to use nylon (non-metallic) screws in these mounting holes. It is also recommended that there is no metal in proximity of the antenna to ensure that signal strength is not degraded.
SDI010-MOD OEM Integration Manual v1.0 3. Device appears with yellow bang (!) on device manager This could happen when drivers are not found for this device or when drivers fail to load. The drivers for this device are available on Windows Update or can be downloaded from http://www.scmmicro.com. If the failure is due to driver load failure, then the reason for driver load failure can be inferred from the device manager message at the General tab. 4.