SCR331-DI OEM Integration Manual Version 1.
SCR331-DI OEM Integration Manual v1.2 SCOPE The scope of this document is to explain the fine points of integrating the SCM SCR331-DI Rev 2.1b dual interface reader modules into other devices. MOUNTING It is recommended that the module is mounted so that the antenna is parallel to the card placement position on the enclosure. The antenna area of the board has mounting holes. It is recommended to use nylon (non-metallic) screws in these mounting holes.
SCR331-DI OEM Integration Manual v1.2 LABELING If the module is integrated in such a way that the label is not visible outside, then the integrator has to display a exterior label referring to the enclosed module. The exterior label can use wording such as the following: “Contains Transmitter Module FCC ID: MBPSCR331-DI21B” or “Contains FCC ID: MBPSCR331-DI21B”. Any similar wording that expresses the same meaning may be used. TROUBLE SHOOTING 1.
SCR331-DI OEM Integration Manual v1.2 DISCLAIMER The module has been tested and determined to be compliant with the FCC and IC rules for intentional radiators. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
