User Manual PRIMIS 7010-B Confidential Author Version Date Document no Sixtus Stanly Rev 1.
Document History Version 1.
PRIMIS Contents 1.0 Introduction ................................................................................................................................ 4 2.0 Reader ......................................................................................................................................... 4 2.1 2.2 2.3 2.4 Functionality .............................................................................................................................. 4 Front/Top Casing View ...........
PRIMIS 1.0 Introduction This document details the Physical Access Control Reader 7010-B PRIMIS Reader and its user instruction and installation procedures. The 7010-B is a dual Technology RFID reader that works with both 13.56MHz and 125KHz contactless Smart cards to enable the card holder access to secure areas. The reader supports an industry standard Wiegand interface for communication with the control panels. 2.0 Reader 2.
PRIMIS 2.3 Isometric View 2.
PRIMIS Back plate 3.0 Product details Product Name : PRIMIS Model number : 7010-B Device Type : RFID reader, 13.
PRIMIS 4.0 Specifications Model Operating Voltage Current Operating temp Operating humidity 7010-B 5 to 12 VDC Av : 90 mA Pk : 140 mA -35 to +66 deg C 5 to 95 % RH 5.0 Product Label 6.0 Product Certification ID’s 6.1 FCC Certification ID – MBPRIMIS-00 6.2 IC Certification ID – 7485A-PRIMISR0 7.0 Installation details Wiring methods shall be in accordance with the National Electrical Code (ANSI/NFPA70), local codes, and the authorities having jurisdiction. 7.
PRIMIS 7.2 Recommended Infrastructure • • • All cabling and wiring shall be UL Listed and/or UL Recognized Cable Wiegand - 22AWG Shielded cable or better. Max cable length for Wiegand is 150m / 500 ft. Cabling shall comply with UL2556 VW-1 for IEC62368 complaint installations Power Supply - ES1 / PS2 Linear DC PSU - 12 V typ, 500mA min. (for IEC 62368 compliant installations).
PRIMIS 7.4 Mounting the Reader 7.4.1 Reference for location of mounting holes on the wall 7.4.2 Reader Installation Steps a. Make the required holes on the wall as per the backplate drawing above. b. The reader is to be mounted at a height less than 2 meters from the floor for MS1 compliance as per IEC 62368-1 c. Insert the nylon screw plugs into the wall. d. Connect the wires as per the Table 1 e. Secure the backplate onto the wall using the Screws f. Hook the reader onto the backplate g.
PRIMIS Page 10 of 12
PRIMIS Power up and Testing 8.
PRIMIS 9.0 Certifications 9.1 FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.