Installation and Operation Manual PAT 13x2 Rev 1.
Installation Instructions: • • Fix the mounting plate in an appropriate position on the wall, where the cable can be easily connected to the back of the reader. Place the reader on the mounting plate and fix it by using mounting screw. This is shown in the picture below.
Mounting plate details Fig 1.1 Mounting plate (Horizontal view) Fig 1.2 Mounting plate (Normal view) PACT 13x2 Outdoor reader- Installation and Operation Manual Fig 1.
Pin details Connector details for Wiegand/Magstripe – 10pin connection Pin Number 1 2 3 4 5 6 7 8 9 10 Signal Name Relay IN1 Relay IN2 Relay IN3 Relay GND Wiegand Data0 / Mag Data Wiegand Data1 / Mag CLK Wiegand LED IN Wiegand Buzzer IN Wiegand GND Wiegand +12V Connector details for RS485 – 8pin connection Pin Number 1 2 3 4 5 6 7 8 Signal Name (Full Duplex Operation ) Signal Name (Half Duplex Operation) RX_A RX_B TX_A TX_B RS485 GND SHIELD Power +12V Power GND RX/TX_A RX/TX_B No connection No connec
CAUTION Changes or modifications to hardware that are not expressly approved by SCM Microsystems shall void the user’s authority to operate the equipment.