PAT 1111 PAT 1121 PAT 1141 PAT 11x1 OEM Manual PAT111 OEM Manual Page 1 of 9
Contents 1.0 Product Specification ................................................................................................................................. 3 1.1 Overview .................................................................................................................................................... 3 1.2 Specification .............................................................................................................................................. 3 2.
1.0 Product Specification 1.1 Overview The term PAT is an acronym for Physical Access Terminal .The PAT readers are designed and constructed to provide a wide variety of configuration options. The readers support contact, contact less and pinpad interface. The PAT 11x1 readers are based on ARM7 processor. The contactless interface is controlled by Mifare IC controller. The readers are designed to support the following communication protocols to interface with host PC/control panel.
2.0 Hardware details 2.1 Product electrical ratings 2.1.1 Voltage rating +12V DC is taken from the control panel and regulated to +5V DC and +3.3V DC on the PAT11X1 PCBs. Operating Voltage is 10V to 16V DC. 2.1.2 Current rating Current consumption is 200 mA @12V for Device full operation. The current consumption during idle state is 160mA. 2.1.3 ESD and EFT As per EN61000-4-2 4KV contacts and 8KV air discharge. As per EN61000-4-4 the product can withstand up to 4KV EFT. 2.
3.2 Contact/SAM Card Parameters Some important smart card parameters, supported smart card types, maximum operable smart card frequencies, operating voltages etc., are detailed in the tables below. ICC Parameters Class A Smart Cards Class AB Smart Cards ISO-7816 compliant Smart card operating frequency Maximum supported card baud-rate Value/Description Supported Supported Yes 4MHz as a minimum (Up to 8MHz) 344,086 bauds 3.
5.0 Duty Cycle The product is designed to work 365 days 24 hours. The RF is always ON for PAT1111 reader. For PAT1121 reader, RF will be activated only when the user enters the correct PIN number. For PAT1141, the reader will wait for either the pin pad entry or the smartcard whichever is first. 6.0 DFU Application DFU is the acronym for Device Firmware Upgrade.
.0 Regulatory Compliance This section describes the product's compliance with U.S. and international safety and electromagnetic compatibility (EMC) regulations. 7.1 Safety Regulations The safety regulations to which the product complies with when correctly installed in a compatible host system are: Regulation UL 294 Title US Safety of Information Technology Equipment 7.
7.4 Product Ecology Statements The following information is provided to address worldwide product ecology concerns and regulations. 7.4.1 Disposal Considerations This product contains the following materials that may be regulated upon disposal: lead solder on the printed wiring board assembly. 7.4.2 Recycling Considerations SCM encourages its customers to recycle its products and their components (e.g., batteries, circuit boards, plastic enclosures, etc.) whenever possible. In the U.S.
8.