PAC21x1 Operation /Installation manual Ver1.
PAC21x1 Installation Manual Version History Date 22-Dec-11 25-Jan-12 Version 1.0 1.1 10-Feb-12 1.2 IDT.QM.P2.T1.DT Description of Changes Initial version – Draft Updated the label and the FCC Class B related declarations Updated the label location and declaration as per request form EMV testhaus REV1.
PAC21x1 Installation Manual Contents 1. Introduction .................................................................................................................................... 4 2. Reader ............................................................................................................................................. 4 2.1 2.2 Top Casing ...............................................................................................................................
PAC21x1 Installation Manual 1. Introduction This document details the Physical Access Control Smart card reader PAC21x1 and the installation procedures. 2. Reader The reader consists of the following parts. 2.1 Top Casing 2.2 Bottom Casing –Potted reader with Pigtail Cable IDT.QM.P2.T1.DT REV1.
PAC21x1 Installation Manual 3. Product details Model Name : PAC21X1 (PAC2131 and PAC 2111) * Device Type : RFID reader, 13.56MHz (HF) / 125KHz (LF) Physical Access control Reader (accessory equipment) Type of equipment : Outdoor use, potted reader, Wall mounted Cable Type : Pigtail Cable , 11 Core + Drain wire. Rating : 5-16V DC (Low voltage) ; Pk Current – 200mA. , Average Current 130mA Communication protocol : Wiegand, RS485 (2 wire- Half Duplex).
PAC21x1 Installation Manual 4.4 Wiring Information Pig Tail Cable Color RED Black Green White Orange Yellow Blue Brown Grey Pink Violet Black Shrink Tube Function + VDC GND Wiegand output D0 Wiegand output D1 Wiegand Green LED Input Wiegand Buzz Input Input2 Input1 RS485 RS485 + Tamper Output Drain Wire Caution: During Wiring make sure that the +VDC lines does not make contact with any other cables, as it might affect reader functionality/ cause damage to the reader. 4.5 Mounting the Reader a.
PAC21x1 Installation Manual 4.6 Power up ad Testing a. b. c. d. e. f. Power Up the reader by connecting the DC power supply at the other end of the cable. The reader beeps long once and blinks red for approximately 30 secs. After this the LED glows RED . Now the reader is in the functional mode. Flash a contactless card on the reader top surface. The LED will blink Green and then turn back to Red, to indicate that the card is detected**.
PAC21x1 Installation Manual 6. Product label For reference purposes only. 6.1 Location of the label. The label is placed on the top surface of the bottom casing as indicated in the figure below. IDT.QM.P2.T1.DT REV1.