BTR-1600HDN with NFC Bluetooth HD Music Receiver With A2DP, Qualcomm aptX® HD, aptX® Low Latency , aptX® normal supported Feature ® ® ◎ aptX HD, aptX Low Latency, aptX® normal codec support ◎ SBC codec support ◎ NFC Quick link support ◎ A2DP Bluetooth profile supported ◎ 66 feet(20M) effective range ◎ TOSLINK digital audio output ◎ Audio RL audio output ◎ 8 devices ID storable What’s in the box Main unit USB adaptor 3.5mm male 3.
Outlook and connectors Front Top View Back Bottom Setup your BTR-1600HDN 2
Analogue connection 1. Connect one 3.5mm end of the include audio to headphone jacket on the BTR-1600HDN 2. Connect the other end to an audio input on your home stereo system (3.5mm or 3.5mm + 3.5mmm2 RCA). Consult your stereo user’s manual for more information on how to accomplish this. Digital connection 1. Connect one TOSLINK cable end to optical jacket on the BTR-1600HDN(recommended). 2. Connect the other end to one TOSLINK input of your home stereo system.
. Your iPod/iPhone/iPad will auto searching available device. You will see “HD Receiver” then Tap on it 5. Your iPod/iPhone/iPad connected to BTR-1600HDN Now. And you can play music from your iPod/iPhone/iPad 7. Your iPod/iPhone/iPad will disconnect 4 6.
Android Phone/Tablet(ver 9.0 as Example with aptX HD support) 1. Go to Bluetooth manager of your smart phone by the following step 1. From your smart phone 2. Inside the setting, turn on home page, tap on “setting” The Bluetooth 4. Searched Bluetooth Devices will show up, please tap on “BTR-1600HD” 3. Bluetooth is turned on 5. Once paired, the blue LED light on the BTR-1600HD will flash once.
Note: Some devices, such as iPhone, will connect immediately after pairing so the LED will ON. Other devices, such as notebook, may ask you if you wish to connect and LED will go off after pairing until a connection is established. Although the BTR-1600HDN can only play music from one device at a time, it is capable of being paired to up to 8 devices. You can play the music now. Just play music on your device as you normally would and the sound will come out from your stereo system.
Indication of LED Indication Meaning Description Flash once 1 sec per 5 secs Power on /Pairing Waiting for connection Permanent Lighted Connected Device and main unit are connected Troubleshooting You can solve your problems from this section No music out from my stereo speaker ◎ Make sure the BTR-1600HDN is powered ◎ Make sure an audio cable or an Optical cable is correctly and firmly connected to BTR-1600HDN ◎ Make sure that the audio source selection of your amplifier is correct with your audio
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.