i-B2X W, Wristband Tag Manual
Wristband Tag Manual Proprietary Notice This document contains confidential information proprietary to IDENTEC SOLUTIONS and may not be used or disclosed to other parties in whole or in part without prior written authorization from IDENTEC SOLUTIONS.
i-B2X W Contents 1 RADIO FREQUENCY COMPLIANCE STATEMENT ...........................................................4 2 INTRODUCTION ...........................................................................................................5 2.1 2.2 2.3 2.4 2.5 2.6 2.7 2.8 PREPARATIONS ............................................................................................................ 5 RECOMMENDED PROCEDURE ........................................................................................
Wristband Tag Manual 1 Radio Frequency Compliance Statement FCC Compliance This device complies with Part 15 of the FCC rules.
i-B2X W 2 2.1 Introduction Preparations This installation manual must be read carefully prior to starting the installation. The described installation works assume that installation materials like cable, antenna and tag holder etc are available. 2.2 Recommended Procedure 1. 2. 3. 4. 5.
Wristband Tag Manual 2.7 Scope of Delivery—Visual Inspection Check delivery whether it is complete and for any damages. If the delivery is not complete or damaged immediately inform the carrier. The dispatch and service organization of IDENTEC SOLUTIONS should also be informed to facilitate the repair or exchange of the system. 2.8 Optical Identification of the Tag The label is on the rear side of the tag, protected by the wristband.
i-B2X W 3 Initial Operation Important Note Do not open the housing! Configuration is done using the built-in air interface of the i-B2X W. Configuration The i-B2X W is configured using the i-PROG MB programming device. Things to be configured • The ping rate: from 0.5 to 60 seconds in steps of 0.
Wristband Tag Manual 4 Tag Mounting Techniques The tag is carried as every standard wristwatch. The band should not be too loose. This avoids that the tag slides down over the wrist and prevents possible injury. For maximum convenience put the end of the wristband under the loop. Now adjust the loop to avoid too much of the band to stick out.
i-B2X W 5 5.1 Maintenance General In principle, the ILR system is maintenance-free. When correctly installed it operates for many years without any problems. 5.2 Precautionary Maintenance Regular checking to the system is recommended. Make sure that the housing of the tag has no damage. If there are any damages as holes or cracks, the tags should be replaced and returned to IDENTEC SOLUTIONS immediately. Regular checking of all ports and cables belonging to the system is recommended.
Wristband Tag Manual 6 Technical Data Operating Data Long-Range RFID (ILR, Beacon Technology) Read range Up to 30 m (90 ft) in free air Operating frequency 868 MHz (EU) or 915 MHz (NA) ISM band Operation mode Transmits a pre-programmed data string in regular intervals Repetition rate (ping rate) 0,5 – 60 seconds, adjustable in steps of 0,5 seconds Transmit power < 1 mW Compatibility i-PORT 4B, i-PORT MB, i-CARD CF B Electrical Data Power supply Battery lifetime expectancy Lithium battery (not replaceabl
i-B2X W Dimensional Drawing Page 11 of 11