Instructions / Assembly

ManualsBrandsIDEAL SECURITY ManualsDoor HardwareKeyed Deadbolt in Black

Table Of Contents

1.750in

44.5mm

1.250in

31.8mm

13/32in

[10.3mm]

2.5in

[63.5mm]

1/16in

[1.6mm]

2 PLCS

.312in

7.9mm

3 PLCS

SKGLK

Template and installation instructions

Warning:

Check door profile prior to installation

You will require a profile wide enough for proper installation.

With the door closed, the minimum inside door profile width is 1-7/8” from the edge of the door frame (glass side) to

the edge of the door jamb or metal door frame (z-bar), which ever is narrower.

The minimum outside door profile width is 2-3/8” from the edge of the door frame (glass side) to

the edge of the door jamb or metal door frame Z-bar), which ever is narrower.

The above warning does not apply to other ways of installations (such as use Z-bar as strike, mortise cutout in wood, etc...).

Determine if your storm door is hinged right or hinge left for proper use of drilling template

From outside of door, looking in, if the hinges are on your left, your door is left handed.

If the hinges are on the right, it is a right handed door.

Ensure that the inside paddle does not interfere with the prime door lock.

cutting linecutting line

RFQSKGLK

PAGE 1 OF 4

Summary of content (4 pages)

PAGE 1
SKGLK Template and installation instructions RFQSKGLK Warning: Check door profile prior to installation You will require a profile wide enough for proper installation. With the door closed, the minimum inside door profile width is 1-7/8” from the edge of the door frame (glass side) to the edge of the door jamb or metal door frame (z-bar), which ever is narrower.
PAGE 2
Template Placement and Drilling Instructions 1. Fold the template on the dotted line to 90 according to the handedness (left or right). OUTSIDE DOOR 2. With the door in closed position, place folded template on inside of door so that the SIDE A is against the jamb or metal z-bar, which ever projects out farther; and SIDE B is on the inside surface of door. 3. Use a center punch to mark the position of 3 holes on the inside surface of door on SIDE B.
PAGE 3
SPINDLE AND SCREWS SELECTION CHART KEY LOCK SPINDLE PREPARATION RULER FOR DOOR THICKNESS PLACE SPINDLE HERE 1. 2. 3. 4. Print this sheet using 1:1 scale. Over lay flat spindle against the image. Mark door thickness on the spindle. Cut off beyond the mark line. Now the key lock flat spindle is ready for installation. DEADBOLT SCREW SELECTION DOOR THICKNESS 1" 1 1/4" 1 1/2"~1 3/4" 2"~2 1/8" 1. Print out this sheet using 1:1 scale. 2. Over lay screws on top of the image. 3.
PAGE 4
Key Lock & Deadbolt Installation 1. Place key lock on outside of door. 2. Insert a flat spindle from inside through the center hole into the key lock. Ensure spindle bottoms into key lock. (If your door thickness is not standard then: The spindle should project through inside of door a max of 1/2" and min of 1/4". Cut off the spindle beyond that length.) 3. Place deadbolt on inside of door, fasten with two machine screws. Do not over tighen screws. 4.