Quick Guide

iData 50 Quick Guide
Home key
Charging indicator
Menu key
Charging USB port at the bottom
Earphone jack
User-defined
function key
Scan key
Rear camera
Primary scan key
Back key
Microphone
Scanning indicator
Earphone
Scan lens
Speaker
Standard USB port
Battery cover lock
Scan key
User-defined
function key
Power key
Flashlight
Overview of iData 50
1
Installing the Battery
2
2. Push the battery cover lock to the right to lock the battery cover.
Lock
Inserting a SIM Card
Micro SIM Card
SIM卡
SIM卡
1. Insert a SIM card by following the direction in the figure below.
54
Inserting a TF Card
2. Open the card cover upwards and insert a TF card, as shown
in the figure below.
Inserting a TF Card
3. Close the card cover, as shown in the figure below.
4. Pull back the card cover by following the LOCK direction
marked on the card cover.
6
(Note: TF cards, namely Micro SD cards, are applicable to the
iData 50. After replacing a TF card, restart the iData 50.)
Removing the Battery
3
2. Pull up the battery cover from the groove at the upper end of
the battery cover.
Unlock
1. Push the battery to the bottom of the battery compartment
and press it downwards.
(Note: The iData 50 adapts integrated design for the battery
and battery cover.)
(Note: Micro SIM cards are applicable to the iData 50. After replacing
a SIM card, restart the iData 50.)
1. Push the card cover by following the OPEN direction marked
on the card cover.
(Note: TF cards, namely Micro SD cards, are applicable to the
iData 50. After replacing a TF card, restart the iData 50.)
1. Push the battery cover lock to the left.
(Note: The iData 50 adapts integrated design for the battery
and battery cover.)
7
You can charge a battery by using:
Charging
1. Charging stand;
2. 1-slot charging & communication stand / Bottom charging cable
(to be purchased separately).
Bottom charging cable
1-slot charging &
communication stand
/ Charging stand
Tips
The following operations help obtain a longer standby duration
of the device.
Shorten the time to sleep by selecting Settings > Display > Sleep.
Set the screen brightness to a small value by selecting
Settings > Display > Brightness.
Disable functions that are not frequently used, for example, GPS,
Bluetooh, Wi-Fi and 3G communication.
Description of charging indicator:
When the battery is in the charging status, the charging indicator
is in red.
When the battery is fully charged, the charging indicator is in green.
When the battery volume is low,
(1) a message indicating that the battery volume is less
than 20% is displayed on the screen.
(2) the iData 50 gives out a low battery prompt tone.
(3) the charging indicator blinks in red.