STAR RF70 PROXIMITY READER USER’ S MANUAL Proximity Reader 20021214 1 USER’ S MANUAL
STAR RF70 PROXIMITY READER CONTENTS 1. Introduction page 3 2. Identifying supplied parts page 3 3. Specification page 3 4. Installation page 4 5. Jumper location page 5 6. Wire Color Table of RF70 page 6 7. Wire Connection to Controller page 6 8. Operation page 7 9. FCC Registration Information page 7 10.
STAR RF70 PROXIMITY READER 1. Introduction The STAR RF70 is a Long Range Proximity Reader for outdoor use and the read range of RF70 is a maximum 7 -foot distance with IDA200 active cards. RF70 can be used for various application such as Hands F ree Access Control, Parking Control and Factory Automations. The RF70 supports various output formats, 26bit Wiegand output, ABA Track II Magstripe output and RS232 serial output and there is an optional mounting bracket to install the RF70 to a mounting pole.
STAR RF70 PROXIMITY READER 4. Installation 4 -1 . Pole Mount using Mounting Bracket (Optional purchase) Install the RF70 to the mounting plate and instal l the mounting bracket to the pole as shown in the photos below, and then adjust the angle of the reader toward the tags.
STAR RF70 PROXIMITY READER 5. Jumper location Open the top cabinet and t here are 5 jumpers in the unit and the location of jumpers are shown in the photo below. The jumpers needs to be set as shown below.
STAR RF70 PROXIMITY READER 6. Wire Color Table of RF70 POWER Power (DC +12V) DC(+) Red wire Power (DC Ground) DC(-)(GND) Black wire INPUT Beeper control input BEEP Blue wire LED control input LED Yellow wire OUTPUT (Wiegand Format) Wiegand Data-0 Data-0 Green wire Wiegand Data-1 Data-1 White wire OUTPUT (ABA Track II Format) ABA(Card Present) CP Orange wire ABA(Clock) CLK White wire ABA(Data) Data Green wire Note: All ABA Track II outputs are open collector output. 7.
STAR RF70 PROXIMITY READER 8. Operation 8-1. Once power is applied, you should hear three beeping sounds and LED changes color to red-green-red indicating that the reader is in standby mode after a successful initialization and diagnosis. 8-2. Present proximity card to the reader until you hear the beeping sound and see the LED changes color to green. The reader will send the proximity card data to the controller then the LED will change color to red again for the next reading. 8-3.
STAR RF70 PROXIMITY READER 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on another circuit. 4. Consult the dealer or an experienced radio/TV technician for help. 10. Warranty and Service The following warranty and service information applies only to the United States of America and Republic of Korea. For the information in other countries, please contact your local distributor.