STAR RF30+ PROXIMITY READER USER’S MANUAL Proximity Reader ID TECK Co. Ltd.
STAR RF30+ PROXIMITY READER CONTENTS RF30-20011104 1. Introduction page 3 2. Identifying supplied parts page 3 3. Specification page 3 4. Installation page 4 5. Wire Color Table of the Reader page 5 6. Wire Connection to Controller page 5 7. Operation page 6 8. FCC Registration Information page 7 9.
STAR RF30+ PROXIMITY READER 1. Introduction The STAR RF30+ is an elegant looking and attractive 12" read range proximity reader which can be mounted on any flat wall surface. The RF30+ uses the electronics module in epoxy potting that ensures successful operations even in harsh environments. The two-color LED of green and red and the inside Piezo buzzer sound will guarantee you accurate and reliable system operations. 2. Identifying supplied parts Please unpack and check the contents of the box.
STAR RF30+ PROXIMITY READER 4. Installation 4-1. Wall Mount Drill two 6-32 or M3 holes 3.3"(8.38cm) apart in vertical and drill one 1/2" hole for the reader cable 1.7"(4.31cm) apart from the top hole. (If you have installed an electric gang box then skip this step and go to step 4.2.) 4-2. Put reader cable into the center hole and install the reader module by using two 6-32 or M3 screws (Not included). 4-3. Put bezel on to the reader module then push bezel until you hear the locking sound.
STAR RF30+ PROXIMITY READER 5. Wire Color Table of the Reader POWER Power(DC +7V~+17V) DC(+) Power(DC Ground) DC(-) (GND) INPUT Beeper control input BEEP LED control input LED OUTPUT(Wiegand Format) Wiegand Data-0 Data-0 Wiegand Data-1 Data-1 OUTPUT(RS232 Format) RS232(TX) TX OUTPUT(ABA Track II Format) ABA(Card Present) CP ABA(Clock) CLK ABA(Data) Data Note: All ABA Track II outputs are open collector output. 6.
STAR RF30+ PROXIMITY READER 7. Operation 7-1. Once power is applied, you should hear three beeping sounds and LED changes color to red-green-red indicating that the reader is in standby mode after a successful initialization and diagnostics. 7-2. Present proximity card to the reader until you hear the beeping sound and see the LED changes color to Green. The reader will send the RF card data to the controller then the LED will change color to Red again for the next reading. 7-3.
STAR RF30+ PROXIMITY READER 8. FCC REGISTRATION INFORMATION FCC REQUIREMENTS PART 15 Caution: Any changes or modifications in construction of this device which are not expressly approved by the responsible for compliance could void the user's authority to operate the equipment. NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions; 1. This device may not cause harmful interference, and 2.
STAR RF30+ PROXIMITY READER 9. Warranty and Service The following warranty and service information applies only to the United States of America and Republic of Korea. For the information in other countries, please contact your local distributor. To obtain in or out of warranty service, please prepay shipment and return the unit to the appropriate facility listed below. IN THE UNITED STATES RF LOGICS Inc. Service Center 3026 Scott Blvd., SANTA CLARA, CA95054 Tel.: (408) 980-0001 Fax.