STAR PDL100 PROXIMITY DOOR LOCK User’s Manual STAR PDL100 Proximity Door Lock 20020704 User’s Manual
STAR PDL100 PROXIMITY DOOR LOCK Table of Contents 1. General page 3 2. Identifying Supplied Parts page 3 3. Specifications page 3 4. Name of Each Part page 4 5. Installation page 4 6. Battery Insert page 5 7. Operation page 5 8. Alarm Sounds page 6 9. Add/Delete Keytags page 6 10. Initialization and Setup page 7 11. Useful Information page 7 12. Important Information page 7 13. FCC Registration Information page 8 14.
STAR PDL100 PROXIMITY DOOR LOCK 1. General We appreciates your purchasing of IDTECK’s Proximity Door Lock which is based on the most advanced Radio Frequency Identification Technology. The STAR PDL100 is a Standalone Proximity Door Lock with built-in 2″ Proximity reader and you can register up to 512 cardholders and it opens the door by contactless technology.
STAR PDL100 PROXIMITY DOOR LOCK 4. Name of Each Part 5. Installation 1) 2) 3) 4) 5) Remove mechanical lockset previously installed. Place an obstacle like a chair between door and doorframe to prevent the door close. Install the STAR PDL100 LOCKSET to the door. Place the GUIDE BOLT upward. Insert two GUIDE BAR into the GUIDE PIN holes of the LOCKSET.
STAR PDL100 PROXIMITY DOOR LOCK 6. Battery Insert 1) Insert 8 batteries(“AA” size) into the battery pack as shown on the right figure. 2) Assemble the battery pack into the indoor unit. Notice 1) Only use alkaline batteries. 2) Make sure that the battery polarity is correct, otherwise it may cause malfunction of the unit. 7. Operation 1) DOOR OPEN (Inside of door) Turn the door handle while pressing the open button. Please make sure to take the keytag with you when you go out.
STAR PDL100 PROXIMITY DOOR LOCK 8. Alarm Sounds 1) Take a Key Alarm When you open the door from inside, STAR PDL100 is automatically locked as soon as the door closed. STAR PDL100 will generate alarm beeps for 5 seconds to remind you to take a keytag. When you hear alarm beeps, please check whether you take a keytag with you before the door closed.
STAR PDL100 PROXIMITY DOOR LOCK 10. Initialization and Setup Initialization is required to delete lost card or to register new master card and keytags. Initialization will erase all memory and setup the new “Master card” and keytags. Follow the steps for Initialization and register new “Master card” and new keytags. Push “Start” button, then red LED will be blinking with start beep sound. Push “Initialize” button of indoor unit. Red and green LED will lit with “Sol-Fa-Mi-Re-Do” sound.
STAR PDL100 PROXIMITY DOOR LOCK 13. FCC Registration Information FCC REQUIREMENTS PART 15 Caution: Any changes or modifications in construction of this device which are not expressly approved by the responsible for compliance could void the user's authority to operate the equipment. NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions; 1. This device may not cause harmful interface, and 2.